Quick head gasket change on my 1983 Honda Gold Wing.

[@michaelpatrick9535]

Thanks you I knew I’d find a video I needed I always say to my son It’s Just Nuts and Bolts I lov the challenger but I also tell him it’s good research not cheating Wish we had this back in 80’s Thanks again

[@shblair]

thanks for this. I have this job do i think.... i just bought an 83 wing. i found oil in the rad rez. havent really noticed sweet white smoke as its still chilly in the great white north. but again ill need this to walk me through the job....this is my first big bagger.

[@breadthroughthefire]

I wonder if i turn my camera off, my gold wing would get fixed over night...lol you make it look easy..lol i enjoyed your video. good job

[@davecallahan2967]

Keep them coming brother.........LOL I feel Ya! Sounds like something I would do......

[@dave1a55]

Does the head gasket say this side out? You said you put the other gasket on backwards?

[@lewismcrae4271]

I have two bikes my z1 900 which is a bitch to do the hard gasket and a goldwing that I have not done yet and the Honda golwing looks like a peace of cake to do towards my Kawasaki great video And right to the point thanks you are the man

[@gabrielpratt8005]

Did you reuse the old head bolts or have to order new ones?

[@GlennsSpeedShop]

Reused the old ones. New bolts a r e likely hard to get

[@gabrielpratt8005]

@@GlennsSpeedShop yes I hadn't found any new ones, but had heard some bolts cant be re torqued. Thank you

[@jamescahill3390]

Coolant resovior on my 1983 gl1100 has drained into the crankcase. Am I looking at replacing head gaskets or do I have block damage? Any info would be greatly appreciated.

[@GlennsSpeedShop]

You will have to pull the heads and inspect the gaskets. Unless you have seriously over heated the engine, gaskets are the most likely cause. Carefull removing the heads to preserve the gasket so you can inspect them and fi d where it's leaking. Good luck.

[@CyberneticVeganism]

When you timed the belts to that "up" position and notch match up, did you have the engine on T-1?

[@Ernestee01]

Criss cross pattern torque , sure

[@redwine3437]

what's up is that a Honda can't see the bike or the motor what's that

[@redwine3437]

that looks like a lot of work

[@milnersXcoupe]

.. check for a bent -sticking valve .. and you hammered the rod bearings .. timing is a mess .. carb sync is a mess .. otherwise ..

[@davecallahan2967]

Volume is real low on this video

[@jeffdevault6596]

I thought you said you didn't rake the rear bolts off the exhaust funny how it just fell off !! Did anyone else here that? Take this guy with a grain of salt!! Reed rhe manual

[@GlennsSpeedShop]

Learn to spell... Read the Manual. LOL...