Рет қаралды 75,763
An in depth look at the Quick Set feature that allows you to configure an Aura without the use of a PC, all you need is your transmitter, and 'digital' receiver.
The actual setup process can be accomplished in just a few minutes.
Be sure to check out the related Quick Trim video also!
NOTE: Firmware 1.4 alters the sequence slightly and the reversing is done BEFORE pulling the bind Plug. Refer to the FW1.4 instructions.
In firmware v1.1 - v1.3, the pilot set the Model Type, Sensor Orientation, and Master Gain functionality before pulling the bind plug. After pulling the bind plug, the pilot would then set the Control Surface directions and check the Sensor Direction by moving the aircraft.
In firmware v1.4, the pilot sets the Model Type, Sensor Orientation, Master Gain functionality, and Control Surface directions before pulling the bind plug. After pulling the bind plug, the servos are now disabled except for testing the Sensor Direction by moving the aircraft.
Jeti UDI can Auto-detect and to Quick Setup if the Jeti setup is set exactly per the recommendations in our Aura Wiki for Jeti Use. (Proper firmware, Flex's .jsn file, etc)
For more information, go to www.flexinnovations.com/aura