RADIOLINK AT10 NOT WORKING

[@matyasdohnal4847]

My problem is power switch. I need replace it. Do you know what type of power switch radiolink at10 have, and were I can buy it? Thanks.

[@23rohitkumar]

My peoblem is power switch too..have u replaced ??.which type of switch..i have to bua

[@alexanderseebauer7026]

Can you tell me where the broken part is and where to buy it. I would be very grateful for your help

[@tomaszsoltysiak7410]

Vario 400 Hello, tomorrow I will try to record and post a video of what and how I fixed it, Regards

[@superslug2516]

@@tomaszsoltysiak7410 Please upload the video

[@tellapoka]

I know mine voltage regulator is burnt too, but I cant identify which one is the voltage regulator, can u let me know which regulator do I have to change??? I have identified the 3.3V regulators but cant find the 5V one

[@pacoxperez]

Open the at10 and check the pin power. Check the contact.

[@tomaszsoltysiak7410]

Unfortunately, I did not manage to read its value, could you give me the value of this regulator ?, temporarily set up regulator from the module realy works but displays a low battery level.

[@pacoxperez]

@@superslug2516 I'm sorry I didn't have that problem, it was Tomas

[@superslug2516]

Sir how did you solve this problem. Please share. I am facing the same issue

[@tomaszsoltysiak7410]

if I find only moments, I will try to give a video, the problem is the voltage regulator, after replacing the radio worked

[@mecatr8nica]

I have the same mistake!. You solved the problem

[@tomaszsoltysiak7410]

Yes

[@mecatr8nica]

Could you to say, what you did to solve the mistake?

[@tomaszsoltysiak7410]

Yes of course, i changed the regulator. because was burned

[@mecatr8nica]

I need buy that. where you bought it?.