Random Orbit Sander, how to pick the right one for your shop.

[@Rusty_ok]

Agree with the corded version as the best option.

[@MadNerdWorkshop]

Agree, I don't like changing batteries all the time.

[@noname-vz5wx]

Great video! Thank you :)

[@MadNerdWorkshop]

Thank you too and thanks for watching!

[@OptLab]

Use a bike inner tube to match any vacuum connectors. Most bike shops toss them. By the way, do you use any jigs to sand at an exact 90° on any edges ? Hand held seem to damage the edge when they are as thin as in your example.

[@MadNerdWorkshop]

Thanks OptLab, I never thought of that. No I don't use and jigs most of the time. You can round over the edges if you are not careful for sure.

[@CJPhillips6648]

When you use a random orbital sander, you should not push down. Let the weight of the sander do the work. Pushing down on the sander slows it down, & the motor gets hot!

[@MadNerdWorkshop]

That is very True CJ Phillips. But after an hour or so of sanding, I do start pushing down, I am guilty of that. However, most sanding test that I have seen of these sanders, do use some additional weight on the sander for that test. If you only relied on the weight of the Porter-Cable or the Ridgid sander you would be there longer than on the others, they are a lot lighter.

[@blayne2029]

Good video! Thanks.

[@MadNerdWorkshop]

Thank you for watching.

[@jimmyreuben6919]

Wondering if you can help I have purchased an ROS and I have only used it a couple of times and am struggling with it, when I trun it on it seems to have a mind of its own and goes all over the place, what am I doing wrong, I see people using them all the time on KZbin and I'm getting frustrated. Thanks

[@MadNerdWorkshop]

it should be easy to use and they do tend to have a mind of their own, but they are very easy to control. You can easily remove the sanding plate and see if the band on the bottom as slipped off or broke, if it did, that would cause it to be unruly. Good Luck with it.

[@CJPhillips6648]

Rockler sells an adaptor kit so you can attach your vac hose to any sander!🥸

[@MadNerdWorkshop]

Very True CJ Phillips, and that is way better than the little bag they come with. I do have that adaptor kit and it does work good, mostly by a friction fit.