Installed it today, great job but my link had to be 25mm instead of 20mm, snug fit for the rest!
@trinitymirror5 жыл бұрын
Excellent work. The servo box/mount is great in design. Another A1 vid
@tonycuong77943 жыл бұрын
It is a very useful video. Can you make other videos similar to it for other Rastar RC cars such as the Mercedes G63?
@stevewatts35025 жыл бұрын
Very neat servo enclosure boss. That front chassis pan and arches would be in tatters, if it was me... I NEED at least 40° steering angle. Ya, I know... nead, my arse ;D
@rizla1_uk2115 жыл бұрын
Great. RC modding at its best
@Alan-hc4jx4 жыл бұрын
Has any one actually used this set up, as have just had to altered the Slec linkage to be 25mm, which is two of the Slec plastic pieces (SL072-S) used without trimming length.
@firmanfirman-zy4dq Жыл бұрын
Hello, what type of ESC did you use? I newbie on this thing...
@matthewpiggott89634 жыл бұрын
do you sell the 3d printed parts for the mods on this model ?? if so where can i buy thanks
@jasoncurrie4752 жыл бұрын
Do you sell the servo mount
@RCMojoTV2 жыл бұрын
The files are on Thingiverse, you can download and send them to a 3D printing service. www.thingiverse.com/thing:3605244
@steveclough67945 жыл бұрын
yeah the tower pro is your1 st mistake i know there cheap have used a few and they always give up pretty soon after install next if you want it to go fast install a small 380 brushless system you can pick them up for as little ass £25,00 from eBay i did a Nikko rally car not so long ago with a 7200 kV motor running on a flurion 2s lipo the thing rips the fly sky is a good choice i use them all the time and very versatile
@bobpaterson58455 жыл бұрын
Hi wiiyou steering servo mount work in the Rastar Hummer
@RCMojoTV5 жыл бұрын
I can't say for sure, but so far of the 3 models I've made servo mounts for, all 3 have be just slightly different
@johnsalt195 жыл бұрын
Can you not cut the springs down a bit
@RCMojoTV5 жыл бұрын
It might for the rear, but I think they might still be a bit stiff
@johnsalt195 жыл бұрын
@@RCMojoTV may ave to source some weaker ones
@ThatGreenGD15 жыл бұрын
Hi, I’ve been watching your videos as I’m doing a new shape Range Rover conversion. Do you sell the steering/servo 3D printed part. The chassis’s and steering setup look all the same across the board on these cars. The chassis shape is just slightly different depending on the car.
@RCMojoTV5 жыл бұрын
Is that the Range Rover Sport? If so my dad should be getting one in the post tomorrow, I'll be able to test to see how the bits fit when he takes the body off. Send me an email through www.74hc.co.uk and I'll see what I can do
@ThatGreenGD15 жыл бұрын
Yeah the 1/14 Range Rover autobiography. Not the evoke