Raven ms- wiring

Raven MS - helicopter transformer humanoid robot
--
3d file:
cults3d.com/en/3d-model/gadge...
code:
drive.google.com/file/d/1gQ9L...

[@YouMakeTech]

Thank you so much for publishing this video, this is very useful and will save me a lot of time. I printed the left arm, now printing the right arm...

[@YouMakeTech]

I'm ordering the servo motors. What do you recommend? Why do you use MG90S and MG92B? should I use only MG92B? Do you use official Tower Pro servos or clones?

[@tangwoonthai]

Mg90s doesn’t have enough torque for certain joints, using full mg92b will be the best, it’s truly good quality and high torque, but expensive. Mg92b is all tower pro I think, for mg90s, you can use either tower pro or diymore.

[@YouMakeTech]

I'm done printing the parts. Amazing design. Unfortunately, my MG92B (genuine Tower Pro) do not fit, the height is too tight, by about 2mm. I probably would need to rework some parts. I really would like to make this robot! Do you have a place where we could share photos/files/comments e.g. Discord?

[@tangwoonthai]

You can built the leg and body first, those part are original using mg92b, I will modify the other mg90s part to mg92b and send you the link later. you can send me photos/videos at [e-mail]

[@pinky797]

did u make all serbo motor 360? It seems like 360🤏

[@tangwoonthai]

180