EdgeTX Snippet • Built-In Curves vs Custom Curves

[@williamcox3852]

Another nice EdgeTX snippet. These will come in handy.

[@johanopperman8039]

Thanks John. You know your video's are always so well prepared and presented. Thanks for your input in this hobby to make it easier and enjoyable for us.

[@ronaldonogueira74]

Hi John, I'm glad my comment inspired you somehow to make another great video. As an engineer I'm a big fan of graphs/ curves for visualization when programming. I've gone as far as using a curve to adjust/match elevator throws in a couple of 3D planes which had very asymmetric linkages (dual servo setup). I simply replaced the linear output in one channel by a custom curve and carefully adjusted the points until both elevator halves traveled in parallel throughout the entire range.

[@mikec9404]

Thanks

[@RCVideoReviews]

You're welcome. Thanks for hitting the tip jar.

[@brianchambers1515]

Nice video thank you👍🤠

[@SBWings]

Thanks, John! If I ever need it, I'll know how to do it.

[@davidblair2007]

I want to set up flaperons but when they are active I want to activate elevons and disable ailerons to just flaps is thus possible or could you possibly make s video to show how to do this i have the freewing f16 i want to set this up on

[@johanopperman8039]

Hi John may I'm looking not look right but I can't find where you can revers a channel in EdgeTX 🙈. Sorry can you please help

[@SBWings]

Go your Model settings. Go to the OUTPUTS tab. Edit the channel you want to reverse. Tick the box named "Inverted". Press Return twice. You'll see "INV" for the reversed channels.

[@johanopperman8039]

@@SBWings Thank you so much appreciate that. 😊