RD350LC Carbs removal and install

[@Angel-rg9mm]

Needle position on the cop can make hole on the top of piston

[@stevenedwards2162]

I have a yds7 runs idles and rides great, but I have to turn the fuel tap to stop position every time I stop as the carbs will fill and overflow, even got into the exhausts, and will never start with a kick I've had to bump start her down a long hill, what would you think would be the most likely cause for this problem.

[@jh-tech5546]

As you explain I would think the float needles are the issue. You might have to check them.

[@peterharding5959]

HOW DID U SET FLOAT LEVEL I SEE USING A VERNIER BUT COULD NOT SE WHAT U USED AS REFERNACE

[@jh-tech5546]

Hi, sorry for the late answer. I usually measure between the gasket surface and the top of the float. Notice the spring in the needle should not be compressed.

[@juanspolzinogomez5588]

Amigo donde puedo conseguir los accesorios que lleva el carburador

[@anandsaig5259]

Beautiful Video Mate . Are those carb Hose clamps the same size front and back ?

[@jh-tech5546]

No, I don't think so.

[@paullynch2159]

Very good,, how are you with the electrics on these bikes, iv checked out the loom diagram but can't make any sense of it , keep up the good work 👍🏻

[@jh-tech5546]

Thanks. I was lucky, all electrics on the bike are in good condition and work fine.

[@sebastianfula1752]

What mm do you use to float

[@jh-tech5546]

21 mm as in the manual.

[@stephenwalsh8184]

🏍👍

[@jh-tech5546]

Thanks