This was so much easier comparing with another guy video on same job…probably took him the entire day to do a job as this one. Thanks for this beautiful video.
@andygonzalez93194 жыл бұрын
If you freeze the bushing hours before doing the job it goes in very easy and I only remove brake line brackets to create slack on the lines and remove bottom shock bolt and lower the axel beam one side at a time. After that I just air hammer the bushing inwards then outwards. The whole job is done within 40 mins tops.
@4121149k3 жыл бұрын
Did you need the tiol clamp he used?
@andygonzalez93193 жыл бұрын
@@4121149k nope just an air hammer and the bits. You bend the bushing upwards all around and then push it out with the air hammer on the bushing lip. When installing adding a bit of wheel bearing grease around the bushing helps a lot. And then just whack it with a hammer until seated. Usually takes 2-3 blows if properly cleaned lubed and frozen right
@4121149k3 жыл бұрын
Thanks for replying! Having a hard time with no tools lol. Will try then.
@DSPNWtoCali3 жыл бұрын
I try to understand or have a visual idea to your method. Do you have a video maybe on how you done it? My look bad enough that I may have to replace it soon.
@Stepheni33 Жыл бұрын
Hey there thanks for sharing. So no need to remove the springs? Just detach the socks and let it hang?
@Ghosts543214 ай бұрын
I'd appreciated some talking to explain what was wrong with the car to indicate if this is the problem i am having
@wheeljack68692 ай бұрын
Thank you!
@car-man5 жыл бұрын
I run the car maintenance KZbin channel in Korea. I'm always learning such a great ideas on your channel. I hope we have a chance to be together. Thank you.
@brettreuben63103 жыл бұрын
@Chase Leonardo Definitely, have been watching on Instaflixxer for months myself :D
@syoung200012 жыл бұрын
Please tell me you’re doing it the hard way and there’s a much easier method 🙏 😭😂
@ahmadlim30352 жыл бұрын
Is it same bushing with picnic / Ipsum 2003?
@TheCreedBratton4 жыл бұрын
where can i get that tool?
@carlosgil93252 жыл бұрын
Crees Bratton You can find the tool on Aliexpress
@TheCreedBratton2 жыл бұрын
@@carlosgil9325 I will check it out. For those without the tool, I hope you like hammering. Best bet is to collapse the bushing through the small hole in the outer sleeve and then cut/pound it out. It takes forever. I made a simple installer that worked well, but these bushings have .015" press so it is an unholy nightmare of a job
@prtbone78 Жыл бұрын
@carlosgil9325 what's the name of the tool is he even talking about?
@dm602s33 жыл бұрын
What is the torque you tightened the bolt at 19:09?