Rebarreling a Remington 40x in 22 Creedmoor. Using our new Omni Adjustable Spider Chuck adapter!

[@cfranklin7450]

Nice to have some new videos posted, thank you and Merry Christmas

[@DustinDrews1]

Merry Christmas to you too! We are going to do a lot more videos. Now that we have our process even further dialed in.

[@1320pass]

Can't argue with those results. Would be cool to see the fluting on the mill. I like watching this stuff. Was thinking about recutting a .223rem to a 22 creed, nice to see you already have the reamer.😉 Barrel I have is a 12 twist Savage 26inch heavy varmint. Was removed because of a boogered up chamber. Was cutting marks into all my brass. Merry Christmas!

[@DustinDrews1]

Merry Christmas to you too! I will do some fluting on the mill. All you wonderful customers are keeping be busy with the barrel work it’s hard to keep content posted.

[@1320pass]

@DustinDrews1 hey that's a good problem to have. With that Haas you've got it dialed in, helps knock out jobs a little quicker hopefully.

[@desertforgeknifetool2142]

The quest for perfection never ends. I have some questions about your reamer holder system and its adaptation to a manual lathe using the tail stock as the feed. I now use a higher end adjustable floating reamer holder and want to switch to rigid tooling. Your system appears to be the way to go. I'll be calling you tomorrow.

[@DustinDrews1]

Forget about using the tail stock. A tail stock is basically a boat anchor on a lathe for gunsmithing. It is slow, it does not repeat, and it flexes under pressure. Use your carriage! You will have to invest in some tool holders. But once you do you will never go back! And if you have a digital read out all the better! Headspace is a breeze. Looking forward to the conversation

[@spencerschulty9528]

Beautiful work as always

[@DustinDrews1]

Thank you so much 😀 excited to do so 20 gt builds

[@jakearchambault8160]

No borescope?

[@DustinDrews1]

lol I completely spaced it with the editing! There will be more videos I promise!