Rebuild BIG excavator bucket

This repair was made in Romania by:
PELADI INT
www.peladi.ro
[e-mail]

[@ruthbees7214]

I like your bucket repair. Very neat welding nice looking strong beads. Good welding practice welders fully protected. Good to see proper job done. I love your welder It looks like a Fronius a well made machine. Keep the video's coming from jonesy south Wales GB.

[@machineryattachments]

Dear Ruth Beers, thank you for apreciation. After comments like your I'll be glad to make more videos.

[@andrewstuckey7736]

That is a lot of work looks good

[@machineryattachments]

Yes, it was a lot of work. Thanks a lot.

[@chadlassiter6380]

Fine looking job! Slick ass beads🤙

[@gilbertbrewer269]

Good job 👍 cut those 5 shanks “adapters” off and put 6 back on. Maybe 7.

[@JoarTroan]

That would be ok on US soil. But in europe. Especially norway the ground is so compact from the glacier time. So here we usually see 4 tooth buckets on just about evereything. And never more than 5. Ive seen a couple with 6-7 teeth. But those are usually used for a rough grade.

[@gilbertbrewer269]

I’ve replaced adapters ‘shanks’ on a Hitachi 1200 6 ft bucket at the quarry. Massive bucket. Cutting old shanks off is only 1/2 the job. 250000 pound machine. I have pictures but don’t know how to send them.

[@machineryattachments]

Dear Gilbert Brewer, this bucket was built 5years ago by us and it was used in mud soil in Romania, Europe. After 5years came to us for a "refresh". In these 5 years, the attack blade and the adapters have never been replaced.

[@JoarTroan]

Gilbert. Daam would like to see that

[@gilbertbrewer269]

@@JoarTroan it was a beast

[@RRaucina]

Seems to me plating over the existing would have been faster and better.

[@machineryattachments]

It was our customer's decision to do it like that.

[@monicabuleandra4108]

Good Job! 👍🏻

[@stevo12378]

Be there for days with those settings 🤣🤣

[@machineryattachments]

Dear Ste James, I don't understand what you mean by that.

[@ruthbees7214]

Hi could you please tell me what gas and wire you use to weld the buckets with. Nice job. Thanks ruth.

[@machineryattachments]

Hello, C18 gas and 1.2mm SG3 wire. Glad that you like it. Thank you!

[@ruthbees7214]

@@machineryattachments thank you very much for your reply. Just for me to know as I am trying to learn is that called dual shielded welding process thanks ruth.

[@frankbertels1119]

"DIE SOLLEN MAL MIT VERNÜNFTIGEM STROM SCHWEISSEN:UND NICHT MIT DER SPANNUNG: