Recording Kemper Main out & DI signal simultaneously

[@DLJMUSIC]

This is the best video I've seen to explain this process. Thanks very much!

[@lassikuusela]

Nice that I could be of assistance!

[@MAV2105]

Even without spdif. Thank you very much for this!

[@lassikuusela]

No problemo :)

[@joeljorgensen4674]

Thanks bro big help! Keep it metal!

[@lassikuusela]

No problem mate, happy to be helpful!

[@davelocke]

Would you by chance know why suddenly I can't get a signal from my DI out? Looking at the screen like the video, my direct volumne is greyed out.

[@lassikuusela]

Hmmm... not sure why you can not get any signal but if you want on be able to control the volume of the direct out then try changing the signal that is fed to that channel. It looks like the volume is greyed out if you are using Di Low but for Di High, Stack, etc. it becomes available. Hope this helps!

[@calitopian4173]

Hi man, thx for this video! I got a question: where do you connect the direct out put send from the kemper back? Do you connect thay to an amp? Or to a pedal board? Hopefully you can please answer my question. Thank you in advance!

[@lassikuusela]

No problem mate! I am going straight to my audio interface and record the clean DI-signal, so I can later feed that to recodred track to an amp if I want to adjust the amp-settings.

[@CrissLiew]

How do you set your output level?

[@lassikuusela]

I check the signal level from my DAW, mixer, etc. and if it needs to be adjusted then I do it on the Kemper's output section.