Recurve GEN4 Installation Instuctions.

Welcome!
Thank you for purchasing the Recurve Tuning Module!
We’re excited to welcome you to Recurve’s video instructional page. Here, you’ll find all the information you need to get the most out of your new Recurve Module and the Powergate app. In this video, we’ll guide you step-by-step through installation, from plugging in your module to selecting the perfect tune for your 4WD. Whether you want to enhance performance, improve towing capacity, or enjoy an efficient engine, we’ve got you covered. Please download the Powergate app from one of the links below and watch the video to get started on your journey with Recurve.
Installation Steps
Pre-Installation Notes:
The Recurve module is also known as Powergate, provided by Alien Tech Australia.
Tuning files and support are from Recurve Academy.
Initial Setup:
Download the app from the App Store and create your Alien ID account.
Connect the Recurve module to your vehicle's diagnostic port.
Ensure the module and your smartphone are on the same Wi-Fi network.
Vehicle Selection:
Select your vehicle model in the app.
Identify the ECU to ensure compatibility.
Battery Check:
Ensure the vehicle’s battery is fully charged and less than three years old.
Connect a battery charger if necessary.
Connection Check:
Ensure all connections between the module and OBD port are secure.
Keep the ignition on when prompted by the app.
ECU Verification:
Ensure the ECU contains the original stock file and no tuning chips are installed.
Pairing and Initial Connection:
Connect the Recurve module to the diagnostic port using the supplied cable.
Wait for the LED to turn blue.
Pair the module with your smartphone.
Enable Bluetooth on your phone.
Open the Powergate app and follow the instructions to add the module.
Wi-Fi Connection:
Ensure both the module and smartphone are on the same internet network.
The LED will turn yellow upon successful connection.
App Configuration:
Search for your vehicle by make, fuel type, model, and version.
Identify the ECU in the app to ensure compatibility.
Control Unit Reading:
Follow the app's prompts to turn the ignition on.
The LED will turn red during this step.
Initiate the control unit reading.
File Processing:
The reading process might take a few hours.
The module will be uniquely associated with your vehicle.
Writing Tuning Files:
After receiving a notification, proceed to write the modified file.
Choose from four tuning options: Power, Towing, Balance, and Stock.
Turn the ignition on and tap OK.
Final Steps:
Ensure all connections remain secure.
The LED will turn green upon completion.
Turn the ignition off and tap OK.
Ensure all logs are sent before closing the app.
Disconnect the Recurve module and enjoy the new driving experience.
Support:
For challenging steps, installation services are available at the Brisbane workshop.
Contact for appointments.
.
recurve.com.au/
[e-mail]
5/71 Flinders Parade, North Lakes QLD 4509
07 3606 0247