Installed this on my 2007 Chevy Impala. This install only took me around 15 minutes. A 10mm socket, two bolts and one electrical clip and the job is finished. Replacing this part solved the engine power reduced issue i was having. In my case, I had two different error codes, the first was for the throttle body's sensor. So, after verifying that code, I replaced it and the car was fine for about a month. The engine power reduced problem came back so I had this new code read and it turned out to be this accelerator also. My issue was at both ends, so I suggest going to a place that will read the error code and verify which one it really is. The secondary issue replacing this part resolved was a random rough shifting problem. Sometimes when attempting to accelerate from a complete stop, the car would lag and then the transmission would jerk into gear. Since replacing this part, acceleration is smooth, responsive, and consistent throughout the whole RPM range. Gas mileage is +2 mpg also!
@milwaukeebrewers63373 жыл бұрын
Same happened to me, but my car worked for 1 day and went back to reduced power engine.. ima see if I can switch the pedal
@SCTR72 жыл бұрын
@@milwaukeebrewers6337 did switching out the pedal resolve your issue
@cctinapatterson73405 жыл бұрын
I'm having coded p2122, p2127, p0123 & p0222 do I replace the pedal too or just the module above the pedal?
@scratchgolfermd3 жыл бұрын
This has come on 3 times on my 2019 chevy Tahoe RST and $1000 each time it happens. When is a recall going to take place?
@jenniferconkel69342 жыл бұрын
They won’t they don’t care it’s a well known issue on these cars and they just think it’s ok let ppl drive them and possibly get killed Bc it stops On the highway 🤦♀️
@dstrohlds5 жыл бұрын
A new throttle body fixed my p2135 and p0223 codes today in my 2010 Malubu 2.4
@motoprophet39813 жыл бұрын
Damn!! Very helpful, that’s what happened to mine!! Perfect video. I appreciate the time you took to do it.
@cliffjumper19845 жыл бұрын
YOU DONT REPLACE THE GAS PEDAL FIRST. There's a bulletin about a harness rubbing against the canister purge solenoid bracket or in that area so you can check that and see if you find an obvious bare wire. Canister purge solenoid is on the left side of the engine as it sits in the car and has a red two wire connector. Look carefully in that area and see if you find anyhting. There is also a bulletin, general in nature, about checking wiring connectors for corrosion and checking for aftermarket add ons installed on the APP circuits. The accelerator pedal has 2 sensors in it and if they don't 'agree' this code will set. Issues with these sensors are generally just there for an instant and then they're gone however the code stays latched until you cycle the key and then as long as the code doesn't reset you can drive normally again. The APP sensors do go bad sometimes but on your car you have to verify the wiring rubbing issue is not present first. *Facepalm*
@susanmendoza35135 жыл бұрын
I have a 2010 chevrolet traverse and it hive me code P2138. So i replace the gas pedal new and also a new throthle body and i still have the same problem. But once the truck heat up it runs fine its only when the truck is cold
@susanmendoza35135 жыл бұрын
I try to erase the code and it will come back right a way and it also say the the 5v circuit is to low ?? What could it be
@Peterbilt-tm1or Жыл бұрын
@@susanmendoza3513 did you find what was the problem. Having same problems just like this
@Mr921822 жыл бұрын
Would this problem be the reason my car would not go faster than 55 mph
@DoitbreakitlearNmoveon2 ай бұрын
Yes it's going on limp mode
@xmsteel6 жыл бұрын
Replaced my pedal today, unfortunately still having the problem. Thinking maybe its the throttle body? (P2138)
@GK7GARAGE6 жыл бұрын
Adam Hickman did you clear the codes, if still try cleaning the throttle body and the gears on the throttle body position sensor
@xmsteel6 жыл бұрын
I did clear the codes. Tried making sure the connection was good in case I didn't get it on tight, but still having the issue. Same codes pops up as before I changed the pedal. I also cleaned the throttle body and MAF. Didn't touch the TPS, but I know those are also prone to issues. I'm just getting a little nervous its something more serious, and replacing the entire throttle body might not fix it for sure.
@williamraysv5 жыл бұрын
@@xmsteel it should be the throttle body. Dif you replace it
@salehalghamdi14525 жыл бұрын
The same thing happened with me. I changed the pedal and cleaned the throttle but the alarms still on. Is it probable to be a mechanical problem that needs to open the engine?
@noelanguiano13813 жыл бұрын
@@xmsteel did you fix it ? What was it I have the same problem. Can you help me by letting me know Thanks in advance.
@ileanalopezvergne53232 жыл бұрын
I am FED up with my 2008 Chevy and these codes!!! P2135 and P2127! I keep getting it “fixed” and still going!
@yettirc3 жыл бұрын
2010 Chevy Impala reduce engine power I changed out the throttle body an the pedal seems to work but maybe after a minute or so the car goes in to reduce engine power again an for some reason I have to disconnect the power wire to reset the throttle body cause when the engine power reduced shows I don't have RPM ... can a bad starter be the cause
@noelanguiano13813 жыл бұрын
Ernesto vera did you fix it. What was it ? I have the same problem.
@jenniferconkel69342 жыл бұрын
@@noelanguiano1381 same here we changed parts it’s still doing it online said maybe be the pcm/ecm and if so it’s expensive it’s the Brain of the car .. if u found out what it was please message back on here :) Tia.
@jenniferconkel69342 жыл бұрын
Did u find out what it was ?
@noelanguiano13812 жыл бұрын
@@jenniferconkel6934 Hi Jenny, On my malibu 2010 The battery was dying. So Replace it and since then it has been working fine. I hope it works for you.
@terrellscaife24113 жыл бұрын
Awesome stuff dude
@R7_Squid4 жыл бұрын
I just have the p2138 code that's it
@chukmorka89393 жыл бұрын
Same! How did you fix it
@DuckandPotatoTV3 жыл бұрын
I put a new throttle body on and that fixed my problem...runs like a new car again!!!
@bobbymcintyre31815 жыл бұрын
Great video very informative 👍✔👍✔
@matthewkuhl96663 жыл бұрын
I literally just watch this so I decided to stop my gas pedal and see if that would work and it worked
@laurenciotorresjr5012 жыл бұрын
Its the code 2127 also a pedal code
@melissaramirez83895 жыл бұрын
I have change the gas pedal, the throttle body and it still bringing me the P2122 and P2138 codes... I don't know what else it could be. And literally I have spend more than 1k trying to get rid of that check engine light
@moneymanscoop73435 жыл бұрын
Melissa Ramírez Check the harness to make sure that the wires are not bad. Or bad ground.
@jaiammons90914 жыл бұрын
Did u find the fix and if so wat was it
@noelanguiano13813 жыл бұрын
I have the same problem. Did you fix it? If you did could you tell me please Thanks in advance
@sylvestersavage42293 жыл бұрын
I changed throttle body and pedal this week. Still throwing the codes
@sylvestersavage42293 жыл бұрын
I've replaced both pedal and throttle body sensor. Still getting code. Replacing the computer this week
@Hova856-sj1iu3 жыл бұрын
Did u reset the check engine light or it reset by itself and how long ?
@chrismartin17705 жыл бұрын
whats p2138pd and p2138pe mean? with the p2138 code
@destinyranee83003 жыл бұрын
Thank you for this i have a 2004 chevy malibu max and this come across my dash and i was scared drove it home by luck lol my bf hooked computer up and the same code was thrown i thought my car was about to blow up lol
@agentcodydanks3 жыл бұрын
I don’t trust anyone with a photoshopped pic
@agentcodydanks3 жыл бұрын
And your an idiot that’s not the set up for a 2004 Malibu. That’s why I’m here. Your sus.
@destinyranee83003 жыл бұрын
@@agentcodydanks I thought u were talking to me haha 😆
@Dee--Jay5 жыл бұрын
I got this cold with reduced engine power also. Do you think it's the gas pedal, the sensor or throttle body sensor
@GK7GARAGE5 жыл бұрын
Scan the codes and go one by one, erase the codes and see which one comes back first.
@lavonn1884 жыл бұрын
Good video bro!
@GK7GARAGE4 жыл бұрын
Thank you
@Joranalsa854 жыл бұрын
excellent video, what were the reasons to replace the pedal? Could you help me with any signs or symptoms that may occur to take to replace the entire accelerator pedal?