Remote Starter installation for 2020 Subaru Impreza using Q9 LCD compustar 2 miles range remote

[@Dwigt_Rortugal]

Me: "There's no way this is a full installation video at 7 minutes!" And yet there it is. This looks surprisingly doable. Not too much splicing.

[@DesertEagle90]

That dont look too bad! But then again I only got the compustar cs4900-s itself... Think I would need anything else??? I was gonna use the t taps instead of sodering. I'm using the 17 Subaru WRX

[@NickBEADG]

Where's the wiring at the steering column you didn't show? Would have been cool to show the specific cable needed for programming, and the programming process on the computer.

[@chimitoc5660]

Doy you have to carry the original key fob with you always.?

[@nicolasbailon2511]

Will this process work on a manual-transmission subaru?

[@mangerningmechanic7931]

Yes sir

[@NickBEADG]

There's one simple extra wire on the manual, you just splice in with a green wire at the clutch switch.

[@basedSTi]

i have this on my 21 sti and suspect its draining the battery... how do i disconnect it being that i didnt install it myself?

[@cubicattache]

Do you try to buy t-harness?

[@mangerningmechanic7931]

I always do hardwiring

[@rodg21519]

Why does Every video stop at this point? I need to see someone actually put the car in drive after remote start! Mine keep shutting Down when I get inside and press the brake which is what the salesman told me to do, he was horrible at explaining!