Removal of Wheel Bearing with 23-Piece FWD Front Wheel Drive Bearing Tool Kit

[@larry1141]

Lol, the cut from him struggling to wrench to smooth as butter is gold. Can I use an impact wrench on this?

[@Matt-rq6wz]

Hmm my abs side race pressed into the bushing on removal. Did I do something wrong or is that something that can happen? The outer race is stuck on the hub too but that’s expected. Now I have a tool bushing with a pressed on bearing race. What size(#) bushing was used to get through the bore of the knuckle?

[@Supermaannnn]

Can it be used to install bearings?

[@dabrokeleague]

What size socket where use to use this tool?

[@jerometruitt2731]

Will this kit work for a 2011 hyundai sonata

[@nnannaokoroji8451]

What is the MATRIC size for the nut and screw in the kit. I just got the kit and will need to order the right sockets to be able to use the kit… Thanks!

[@ScottYouger]

32 mm for the nut and 1" 1/16 for the bolt. At least in my case.

[@nnannaokoroji8451]

Thanks!

[@yaboihappy1629]

Can it be used to push out bushings as well?

[@orionmotortech1033]

Yes, it can be used to push out the bushing. For more information you can email us at [e-mail]😀

[@justinkim3516]

Is this tool able to remove and install the hub as well?

[@onlywenilaugh6589]

Yep

[@dannywilliamson3340]

Will this hold up to a powerful impact wrench??

[@jordansumner4374]

No. There is a disclaimer in the box that states not to use an impact when using this kit.

[@DONTCALLMETHAT]

replace the bolt for a grade 8 bolt and you're golden

[@tenzackyogi1742]

Is it applicable to idler pulley & drive tensioner?

[@dalegene1729]

How does this tool remove the wheel hub? Please demonstrate

[@keyrealm3312]

You’ll need a slide hammer to remove the wheel hub friend!

[@radius4914]

Or you can just use a socket and hammer that baby out!!

[@dennisjohnson5285]

@@keyrealm3312 Yes a slide hammer can be successfully employed but a better option is to use the Orion tool itself. The force required is less than that required to remove the wheel bearing, and additionally in most many cases can remove the inner race at the same time the hub is removed from the knuckle allowing the reuse of the old hub if the hub in satisfactory condition at the time of removal. And removes the extra time and effort required if the old hub is removed by pounding out manually and usually always requires the necessity of removing the old race viva a cutting tool. The cutting tool can successfully accomplish the task of removing the old race in order to reuse the hub A hub puller is a better option over a slide hammer. Less stress iis generated on the hub compared to a slide hammer. Even though a slide hammer can be employed to remove the hub without damaging the hub...

[@philip.aocallaghan4602]

That is complete bullshit...they are next to impossible to remove. on occasion, these bearings will put a 20 ton press to its limits. Don't believe everything you see. I know i do this for a living

[@mikeroshop8913]

I use it all the time, learn how to wrench....