Removing and Replacing the Auxiliary Belt Tensioner - Peugeot 307

Removing and replacing the auxiliary belt tensioner on a 2001 to 2008 Peugeot 307 with the 1.4 petrol engine. The part number is 9652073680. Thanks for watching, please comment, like and subscribe !.
All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.
© / screwsnutsandbolts 2020
Read important information below:
Disclaimer
Under no circumstances will Screwsnutsandbolts be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Screwsnutsandbolts or a third party. In no event shall Screwsnutsandbolts be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against improper use or unauthorized modifications of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Screwsnutsandbolts recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts.

[@gazjonze]

My OCD went off the scale seeing the old part put back on 🤣

[@mikhailchyorny7275]

Thank you very much. It helped me with my 206

[@screwsnutsandbolts]

You're welcome!

[@matthewbassett6852]

Hi doo you still have a part number at all please

[@screwsnutsandbolts]

@@matthewbassett6852 RIDEX 310T0047 is one part number.

[@pedrosedan1466]

Qué torques llevan los bulones del tensor y la polea? Muchas gracias

[@screwsnutsandbolts]

Hi, the pulley bolt is 45 Nm (33 foot pounds) but I can't find the torque settings for the tensioner housing bolts. It's not listed in the workshop manual, sorry.

[@pedrosedan1466]

@@screwsnutsandbolts Muchas gracias, muy amable

[@toxmaster1]

Maybe you should replace it really, that bearing is little bit "noisy" :)

[@danwiddison]

What if you just want to replace the pulley itself not the housing?

[@screwsnutsandbolts]

You just have to remove the center bolt

[@ualias9906]

@@screwsnutsandbolts Is the bolt reverse threaded? Which way do you turn to remove?

[@screwsnutsandbolts]

@@ualias9906 No I dont think it's reversed

[@Northyorkspaul]

First off if your cars getting on a bit don't Jack it up there.