More room is needed when removing the brake master cylinder. Special tool such as a cow foot set can make the job easy.
Пікірлер: 18
@on2197 Жыл бұрын
If you are replacing a brake booster the set comes with all the pushers no need to keep the old parts. The pusher, sprocket and small metal guider is inside your brake booster as follow.
@maniraguhayesaya87612 жыл бұрын
Thanks
@ryanrobinson76465 жыл бұрын
AT THE END OF YOUR VIDEO, IT SHOWS THE PUSH ROD, LOCKING RING BUT THE SMALL METAL DISC, DOES IT SIT BEHIND THE PUSH ROD?
@rothmondtero93043 жыл бұрын
Yes it is behind the push rod and it was difficult to put it in. Hi Ryan, is the PUSH ROD supposed to be secured by the crown looking lock ring inside the booster. Please share your experience if you been through this. Mustafa don’t reply on his video. Thanks
@rothmondtero93043 жыл бұрын
Hi Mustafa. Do I have to secure the PUSH ROD with the locking ring inside the booster. Please help. Thanks
@azutazo52932 жыл бұрын
Hi, What is the position of the metal snap ring on the magnetic part ? Thank you
@rothmondtero93043 жыл бұрын
Hello Mr. Mustafa. When I pulled the master cylinder, I only saw the push rod and the locking ring. You think the small metal disk fell inside the booster? And if I have it where do I install the small metal disk. I think your video was the best so far of all because it was so in detail BUT at the end you did not explain where those three parts exactly goes in. You think you can explain how to install it even only in words. Thanks, Rothmond
@jovandavislubiano92782 жыл бұрын
I have the same issue, when I installed the master cylinder with just the push rod and the ring gear the brake was spongy and rear calipers doesnt work
@robertjackson32004 жыл бұрын
Where do I place the small metal disc ?
@rothmondtero93043 жыл бұрын
Hi Robert. Did you happen to remember what to do with the push rod and the locking ring? I was able to figure out about the metal disk but not about on how to secure the push rod inside the booster with the locking ring. I hope you can help me. Thanks
@gracanin854 жыл бұрын
You didnt show the rest.
@armandohilario4 жыл бұрын
How you putting back the pushing
@rothmondtero93043 жыл бұрын
Hi Armando. Will you able to figure out how to secure the PUSH ROD inside the booster? I hope you can help me. I’m stuck right now in this project. I can’t find any answer even in google. Thanks
@armandohilario3 жыл бұрын
You have some pictures of the booster
@rothmondtero93043 жыл бұрын
Yes, I have a endoscope camera and able to take photos inside the booster. But still I can’t figure out if the push rod is needed to secure by the locking ring.
@armandohilario3 жыл бұрын
You have to put back the push rod and after you put carefully the master cylinder
@rothmondtero93043 жыл бұрын
Thanks for the reply Fernando. But what about the locking ring? Did you remember how to secure it or simply just put it on top of the push rod.