Removing Rear Bushings on a 2003 Honda Civic Si (EP3) - Part1

[@fewhavestrength]

I'm going to hacksaw the two ends off and use a bush press, this seems hard work. cheers for the video, as I could think how to do whilst watching you 👍🏻👍🏻🍻🍻

[@GabrielOrtizUAP]

Just what I needed to see. Very masterful work. I just ordered my ball joint separator fork. Thank you.

[@bradleydavidgood]

Thank you for the video. How did you remove the cam alignment bolt that you said was stuck at 0:50? Is it the bolt in the center of the picture at that point?

[@yannis92preloude]

Hi Murat. I have to do bushes as one has broken from deep rust unfortunately I dont have to 2 center pins one has broke of. I saw the way you have taken them out . one the oem bush is the slive neck at the end off the bush, so only to be press in one way, I have found some replacements with both pins out. but I could not make out bush gose in both ways only or one way on oem bush. I know on aftermarket bush you have to use the old pins. so from the video I can only side of the metal slive from the bush.

[@79Zoro]

Wooooww You save my life

[@muratsrandomfixes]

Thank you. Glad it helped. We are a dying breed with our cars :-)

[@screwdajuice]

Great work, just need to be careful to not breathe in the burnt rubber.

[@muratsrandomfixes]

Thank you very much. The smoke was definitely more intense than I expected

[@fewhavestrength]

zero lube!

[@cameronslack9807]

just buy a press