Removing the taper lock pulley on the phase converter motor

[@brushfirehail]

This takes me back to my years in the oilfield industry we had to change them as routine maintenance. It looks to be one of three brands either woods , Martin or browning. They all used to have the same dementions. I.E they were interchangeable. That looks like a Q1 1-3/8 hub and a 2b12 pully or sheave as some may call it.

[@TrPrecisionMachining]

very good job..thanks for your time

[@smalltownmachineshop6860]

And thank you for taking the time to watch

[@machinistwanttobebrianfrom6887]

Brian from Ma.Great video i have a ? im restoring a van dorn 6 inch heavy duty bench grinder it worked but something heavy fell on it an devastated it any way i rewired it it dont work now wondering i had to put what might have been to much heat soldering the capacitor could heat ruin a capacitor i double checked everything else thanks Besafe

[@smalltownmachineshop6860]

Does the spindle still turn really freely

[@machinistwanttobebrianfrom6887]

@@smalltownmachineshop6860 Yes

[@smalltownmachineshop6860]

It takes a lot of heat to ruin a capacitor in my experience, in a very safe manner, spin the grinding wheel and flip the switch when your hand is well clear and see if it starts spinning, that will indicate a bad capacitor

[@machinistwanttobebrianfrom6887]

@@smalltownmachineshop6860 i think that is what it is i did do what you said and it just free spins Thanks Besafe

[@MS-be9wv]

Could we make alignment for pulley?

[@smalltownmachineshop6860]

Like a video on how to align them

[@MS-be9wv]

Where is the video?

[@MS-be9wv]

My question is, I can move the pulley forward and back, until I get the two pulleys aligned, then I can tighten the pulley screw

[@smalltownmachineshop6860]

@@MS-be9wv yes and sometimes you need to be just a bit off to one side as when it’s tightened sometimes it wants to pull it just a little one way or the other but you can put it anywhere on the shaft

[@MS-be9wv]

@@smalltownmachineshop6860 many thanks

[@kentuckytrapper780]

I bet that was my motor wasn't it? Lol, I'll eventually find one,I'm looking at American rotary outside 30hp converter. Great job on the pullie, they can be a bitch.

[@smalltownmachineshop6860]

It’s motor I’m using to test all my other motors, a once totally reliable source of cheap motors for me has unfortunately turned out some bad ones so I’m going to test my entire inventory of 3 phase motors which is around 30