removing a pulley from Rolair Compressor motor for an upcoming project stay tuned !!!!!!!!! thanks
Пікірлер: 23
@ivancollazo3164 Жыл бұрын
Man, I just love this woman, she is a splendid teacher. I was almost to give up on the same situation she was working on. She acted so calm, without suffer and without giving up. My thumbs are up for this Lady.
@MNNICEGaming2 жыл бұрын
I was just scrolling through your videos while watching this one and I just love how it’s tons of videos of you just doing things ! Here I am looking up videos on how to do stuff and I should just be more like you and get out there and do it!!
@danpincus91416 жыл бұрын
This really is a good video tutorial on removing a pulley. I'm trying to remove the spindle pulley on my drill press and have only found one where it only explains a little bit about how to do it. I like this video because it methodically runs through the process of removing a simple pulley. I can apply what you carefully demonstrated here to the spindle pulley on my drill press. Thanks! Great video!!
@animecatgirl144 жыл бұрын
Thank you
@jetblackstar5 жыл бұрын
well I'll be damned, thats what that contraption is my late Dads workshop was for. Turns out I already have the tools for this. Thanks for the video. Good stuff!
@animecatgirl144 жыл бұрын
HAHAHAHA! I'm happy I could teach you something.
@albertcamerato76732 жыл бұрын
Clear instructions, also good idea to remove set screws as some assembly use two in each hole,one to secure wheel to shaft,2nd to lock 1st in place. Belt and suspenders.
@jacksmalls73682 жыл бұрын
Love the accent.
@davidseanez82173 жыл бұрын
Thank you so much I learn something new today!:)
@P61guy613 жыл бұрын
May not be relevant, but I’ve restored pulleys by carving a stick of wood to match the inside groove of the pulley and make undersized to make room for sandpaper. Then run the engine and use the tool to sand the groove clean and smooth. Of course, make the stick long enough to be well out of harms way and only sand on the side rotating away from you so the wood isn’t thrown towards you if it hangs up in the spinning pulley.
@sgtcote13 жыл бұрын
Thanks for the good tips.
@zonianinexile3 жыл бұрын
Thank you!
@Stang4133 жыл бұрын
Do you know what size puller that is? I think I need a 6 inch puller for a pulley about the same size as the one you did.
@chax20045 жыл бұрын
Great video
@animecatgirl144 жыл бұрын
thanks
@Shamweeniedog104 жыл бұрын
How do you put it back on?
@locogarcialg24 жыл бұрын
Buen video
@mikefreedom56125 жыл бұрын
Thank you
@animecatgirl144 жыл бұрын
No Problem!
@halfacubey3893 жыл бұрын
now try doing this on an ancient briggs 9hp pressure washer
@bernardb49013 жыл бұрын
Lol im doing it on a 1979 stiga park the pulley bent on itself 😂
@rodneyyanvari7984 жыл бұрын
Should remove the set screws first
@nathanmciver64963 жыл бұрын
Lol, it's one of those things! You watch a video like this to justify the reasoning on why this would be a good item to buy! And after seeing that you hurt your arm this makes a tool like this valuable!!! Ugh!