LOWERING SPRINGS TESLA MODEL 3 | DIY FULL VIDEO LR/P

[@rikoskokos]

Dude, many thanks for review and installation process! Especially for notice about P3D suspension difference.

[@rudygosteli6802]

Very informative. Thank you for going through all the trouble to film it. I’m sure that adds to the complexity of the overall project. Car looks great. Whether or not I try this myself depends on if I have. 13mm socket that fits. If I don’t, it’s God’s way of telling me to take it to a mechanic.

[@FrostyFingers]

Rudy Gosteli cheers happy to hear that

[@arodg]

does it bug you how your rims are directional but theyre all the same so one side of the car is going the wrong way.

[@fla850boi]

that red stripe above your side shirts looks cool! Can you tell me what it is?

[@FrostyFingers]

Vinyl 💪🏻 Think I made a video about how to

[@ASpec818]

What are your current hub (center of wheelcap) to fender measurements after the springs settled? I measured 375mm front and 365mm rear on my eibachs but I think I like the ride height of the h&r’s a bit more!

[@The-Northern]

358 frnot 365 rear

[@VladTechGuy]

hey, if i was to do this myself, any tools I need to install/compress the spring when installing? or is it just replace and all good ? thanks

[@FrostyFingers]

You need spring clamps, and the right torx and pipes. Other than that nope

[@drx630]

Did you trim your bumpstops (my eibach springs suggest 20mm trim front, 25mm trim rear)?

[@FrostyFingers]

Nope no need to

[@Abdullah-zh3po]

Great video, just one question. I have awd non performance, would the h&r springs work on it or just the performance variant?

[@FrostyFingers]

Abdullah Farid yeah you get them for the LR too

[@jvoutube]

Any alignment issues? Tire wear unevenly too much? Thanks for the vid.

[@FrostyFingers]

Had a 4 wheel controll. It was almost perfect. In other words, it was not perfect OEM :)

[@Shivnandak]

Hey man, just an FYI - i have a dual motor non-performance and the drive shaft goes the strut just like yours. Maybe Tesla changed the design recently.

[@FrostyFingers]

Yes! I did confuse with RWD. Think I also had some txt in the video clearing it up

[@Shivnandak]

@@FrostyFingers I just tried doing it and got stuck because my allen key wasn't long enough for the top strut nut (didn't have an impact). As you said in the video - it's not that hard. But i would pay someone next time just like you.

[@FrostyFingers]

Done this 3 times now and I use about 2 hours on both front and 20min on the back. Gets easier.

[@bollemuslol]

enjoy crushing your car in speedbumps

[@FrostyFingers]

Not an issue...

[@cooram]

@@FrostyFingers worth

[@FrostyFingers]

@@cooram worth ?