LG Dishwasher Replace Circulation Pump Motor

Рет қаралды 80,211

Күн бұрын

Пікірлер: 17

@ericburke2326 10 ай бұрын

Great content, I would only add that you might as well replace the motor shaft seal while you’re there. It’s the black seal on the inside of the dishwasher where this part exists into the dishwasher. My seal failed a month after I replaced this part. I found water on the floor and my dishwasher kept tripping the breaker. Had to repeat steps one through…🎉

@repairclinic 10 ай бұрын

Thank you!

@hockley91 11 жыл бұрын

THANK YOU!!!!!! Thanks for showing the step by step instructions....I was at a loss for a bit. Got the motor in the mail and then I didn't know how to completely remove the old one....Appreciate it!!!! Adam

@repairclinic 11 жыл бұрын

No problem Adam!

@lespullins2940 10 ай бұрын

What lubricant would you use on the seal when installing the circulating pump motor shaft into the seal. The seal from the factory in the sump has a white luricant on it. Is there a video to replace the motor shaft seal?

@kjellsteel 9 жыл бұрын

HI, is this simular to the LD-2120 whu? I have some noise in the motor.

@syndiana 7 жыл бұрын

Thanks for this excellent video. Could you please show us where is the power fuse on LG 3850DD3006J ? Thanks

@anilamarakoon6319 10 жыл бұрын

Great instructions. Thank you.. how do you figure out that motor is bad?

@repairclinic 10 жыл бұрын

The best way to diagnose your dishwasher using the repair help section of our website: www.RepairClinic.com/repairhelp?TLSID=1773 - if you enter your dishwasher's model number there you'll have access to part, model and symptom specific repair help and troubleshooting.

@premsequeira7173 9 жыл бұрын

Hi. Cud use your help on troubleshooting my LG unit - LD2131SH. Have an error code E1 coming in about 3 minutes into the cycle. Also noticed a bit of water leakage at the rear of the unit on the floor. Had the same error on the unit some time back which was rectified by a technician who externally freed the motor which seemed to have been jammed. He suggested replacing the motor but the cost was prohibitive. Post that the unit worked albeit with a bit of noise during the wash runs. Wanted to open up the unit but noticed that the machine cannot be opened from the bottom as demonstrated by you. Any suggestions or a video on a similiar problem unit?!?pls advise. Thanks mate.

@repairclinic 9 жыл бұрын

Ethan Bennett E1 is a leak error for LG units which explains why you found water. The wash motor does have a seal in the pump so you would have to disassemble the unit to see what is going on. That model LD2131SH is not in our database so we don't have any information on how it comes apart.

@premsequeira7173 9 жыл бұрын

Thanks mate......will try to figure it out over the next few days......keep you posted if successful.