Repairing Cracked Flywheel of a Clutch pressure plate Grinder…

[@sassaraowalter5241]

An excelent professional . Great job.

[@REVERSE_BIAS]

That's it mate.....brush off the dirt...then flip it over into...more dirt.

[@villagestreetfood1230]

Nice worker

[@dumbotater2158]

So how do you fix the cracks???

[@frankhardy123]

That flywheel is going to shatter under any serious load. It's cracked in multiple places. The driver better hope the engine firewall is reinforced enough to absorb metal fragments flying at it, otherwise they're dead.

[@buyamerican3191]

Amazing mechanics??? more like it will be amazing if it doesn't blow up! So what was the fix for the cracks? I missed that part. Better install armor plate around that flywheel! Hammer and chisel, you guys don't spare any expense do you? You knew how much to take off the tangs just by eye? you guys are awesome.

[@a.f.1587]

I thought they are going to weld the cracks but at the very end of the video there were still huge cracks on it. And the guy showed thubs up. So that was the fix? They basically surfaced it in a lathe and that's it? That thing will blow up under load and will kill them. Natural selection i guess...

[@jibrankhan7810]

Good attempt

[@AwaisHafiz-li6kb]

kasa ki ha tar motor pahly kon se poly ha Akher per kon se ha

[@georgegonzalez2476]

It’s cracked. Better tell the driver to keep it under 2200 RPM, not slip the clutch, and sit on some armor plate.

[@AwaisHafiz-li6kb]

السلام عليكم ورحمة الله وبركاته

[@WowAmazingRestoration786]

amazing

[@kidshome9747]

#mechanical #hardwork

[@AwaisHafiz-li6kb]

Hello