Replacing Clutch Spring on Kawasaki Nomad 1600

[@jimmacdonald1147]

Thank you for taking the time for the rest of us.

[@KJ6UXW]

Thank you sir for this video. Im going to be doing this on my 2005 VN1600 Nomad

[@ronniec8038]

This is a really good video. Thank you for posting it.

[@rubenarbelaez7964]

hey thanks for video.after you replace spring the clutch level it is more hard to compress them before?

[@johnloar6008]

shouldn't use grease. put spring and washers on center and install as an assembly

[@ZEUS-xt3dt]

I have 2002 Kawasaki eliminator BN125 I'm changing the entire parts including the frictions plates

[@jeeplover2004]

at 23:25 when you put the rod back in was there just a bearing or was there a washer to

[@jdmmurray1023]

How to put the rear rear drive apart

[@carykane5219]

why didn't you even check the friction plates ,how many miles are on your bike

[@carykane5219]

ok thank you

I would have repall plates. Withnall the work of just replacing the spring

[@GRPPLRJORDAN]

Did you torque the bolts on the clutch cover or is hand tightening enough?

[@chaoticadventure]

10ft lbs

[@dschworn1]

what type of grease did you use to hold washers....thanks great video

[@dschworn1]

Mikolaj Stachura thanks this is my winter project!!

[@jdmmurray1023]

Shaft drive rear end putting apart

[@mangasingh8050]

You the nut with wind gun now tight with tq you only got few turns

[@JonJon501]

Are you responsible for the damage I did to my engine?

[@2008goldwind]

Should have changed the discs when you were that far in.

[@nickmduran7310]

min 10:32 lol😂