Replacing Rear Axle Bearings on Polaris Trail Boss! STUCK AXLE NUT!!!

This Polaris Trail Boss was in desperate need of rear axle bearings and man did it put me to the test. This job probably took me 5 hrs to get you guys just 9 mins of video. I was not expecting that. I had a 3" piece of pipe laying around that I used as a breaker bar and the air hammer came in handy way more than I imagined.
Affiliate Link
Air Hammer: amzn.to/3BtQmxz
Air Hammer Bit Set: amzn.to/3f0Zouf
Visit us at www.toyshop966... to see what were up to and to check out everything Amsoil has to offer!
Check us out on Patreon! www.patreon.co...

[@simplylegit1169]

It’s amazing the specific videos you can find on KZbin, thanks for your help

[@oldschoolfz]

What torque did you use for the sprocket hub and jam nut. I've found two different torque values

[@ToyShopRestorations]

I would give it probably 2 ugga duggas 🤷🏻‍♂️😅 I don’t know what the spec is 😬 and I didn’t set it to a specific torque. Just by you asking me that question I’m assuming you’re a better mechanic than I am 😂😂

[@clanoffun8819]

My sproket ie stuck

[@ToyShopRestorations]

That sucks. 😅 Spray it with WD and try to heat it up?

[@clanoffun8819]

@ToyShop9665 I got it out I just hammerd the axle out with a mallet

[@juggalo3094life]

What the part ## on the bearings

[@ToyShopRestorations]

I’m not sure. The kits aren’t expensive. Get on eBay and type in your machine and search rear axle bearings! They should come right up!