Replacing Rear control Arm Bushing on a Mercedes w210

To replacing rear control Arm Bushing on a Mercedes w210, you need to remove the wheel, then unscrew the lever bolt. You do not need to shoot it all .Now either knock out or press out old arm bushing . And the new one presses it in its place. Next, we collect everything in reverse order.All guys, that's how changes Rear control Arm Bushing on a Mercedes w210.
** If the video was helpful, put a "thumbs up" and subscribe . **
→ Become a Auto Serice Subscriber: / @autoservice.
*If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Week*
Disclaimer:
Due to factors beyond the control of Auto Service , I cannot guarantee against improper use or unauthorized modifications of this information. Auto Service assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Auto Service recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Auto Service, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Auto Service.
We offer Comprehensive Vehicle Reports at competitive rates
bit.ly/3zKNkWn
Is $34.99 too much to pay Carfax for a vehicle history report? Our customers think so. Sell VIN history reports for $9.99 each. Approved first-level government data provider.
bit.ly/3OlDUFn
Gov-Auctions.org - #1 Government & Seized Auto Auctions. Cars 95% Off!
bit.ly/3O7G9vB
eBooks - Ford Shop Manuals and Service Manuals
bit.ly/3zHK5iq
Mountain Directory: A Guide for Truckers, RV and Motorhome Drivers
bit.ly/3bbmcpk
RepairSurge Online Auto Repair Manuals
bit.ly/39DrlpG

[@malcolmlane-ley2044]

Good video, thanks for this. Mine's an R129 but it looks very similar so the procedure should be the same.

[@BobBenz55]

Yeah it’s exactly the same. Doing my SL, got the tool thou so much easier: laser 7791. Good video thou 👍

[@BobBenz55]

Thanks, so mush easier thou with the laser 7791 tool. 👍

[@autoservice.]

ok

[@mattfinleylive]

Excellent! Thanks!

[@autoservice.]

Thanks .

[@simonpraudayraud3685]

hello, i'm doing the same job on mine and i've real difficulty to install the new one, how did you do it ?? Did you just use a hammer ?

[@autoservice.]

i used press

[@simonpraudayraud3685]

@@autoservice. so did you have to disassemble the whole thing or just put the press on the part?

[@arnietwo11]

Poor should have shown how to install new bush ??

[@autoservice.]

It is easy

[@ruisalvador3516]

How to press not show

[@autoservice.]

greased the edges of the sleeve and the seat, it can freely enter by tapping

[@niekruiter3497]

Shows no information how the new unis was instaled

[@autoservice.]

ok i ll make video

[@ionutardusadan2868]

Ce poziție avea roata înainte de a schimba bucsa??

[@jamesbest9741]

How u fucking get it out 😡

[@ZAUR.79]

Qaqaş təzəsini ora qoyanda nəilə sıxdın özü rahat girdi

[@daeshbagcentral5298]

Hopeless video😢

[@autoservice.]

You don't understand