Replacing u-joints and carrier bearing; 2005 F350 Crew Cab Long Bed

Longest video I've published so far...

[@5400bowen]

You guys used techniques I can do, but most of the other videos on tube didn't have any I can afford the tools for. Thanx for the info, nice to watch you execute it as well.

[@SixOFord]

Just did this yesterday. Man having a press is nice. My days of hammers and sockets are over lol.

[@70ixlr86]

2 or 3 jaw puller to get the carrier bearing off. Chilling the splined shaft, using upside down pc dust blower cans or Ice makes the new bearing slide on much easier.

[@alejandroz4265]

Rest in peace Marky mark

[@skullyboy95]

I love how you keep repeating lefty loosey, cuz I do the exact same thing 😂😂 and thanks! Needed this video!

[@benking4367]

After wracking my brain and exhausting my bank account .. It was that damn Carrier Bearing !!!

[@luckyred1818]

Thanks for this vid. Helped. 12:50 i knew a crackhead that used to say that, lol! Goodspeed pookieboy

[@jordandeapen9535]

So you ended up using 4 p330s? Thanks for the video

[@TheFritz423]

3 not 4 but yes.

[@royquesada5295]

Why does the carrier bearing look the other direction then when you were pounding it in?

[@TheFritz423]

I edited out that fiasco. Lots of bad words.

[@kirkkirkham7538]

1 1/4 pvc works

[@tommytc75]

At what speed does vibration start

[@TheFritz423]

It began at 30 mph, then disappeared until around 60 mph where it started again

[@imaslowlerner]

My drive shaft fell off on the way home , carrier bearing bracket ripped off, drive shaft came apart. Removed it with help of passerbys, unfortunately didn't mark locations, the u-joint housing is so rusted out that I'm going to have to replace the whole unit😖.

[@jamesmacdonnell4085]

My driveshaft also fell off, a 2004 Ford f350 dual rear drive dump truck. Instead of the driveshaft falling down, it fell upward, grabbed the wire harness along with diesel fuel tank line..twisted them round and round the driveshaft like spaghetti on a fork. A big mess, I think carrier bearing bracket failed. Not sure if driveshaft is bent, where can I get it checked? From Boston MA bought truck new has only 34000 k miles. Thanks in advance for any help, where do I send driveshaft for straightening? Jim

[@imaslowlerner]

@@jamesmacdonnell4085 : sorry to hear that, I had a hard time finding someone that could fix it, everyone wanted to sell me a brand new driveshaft. So I went to the junkyard and couldn't find one. The guy at the junkyard gave me a business card , I called the guy, he was 75yrs old and had my driveshaft with new bearing ready in 3 days. I'm in Arkansas so that information ℹ️ may not help you.

[@imaslowlerner]

@@jamesmacdonnell4085 : forgot, he only charged $289, all new ujoints, bearing, and fresh coat of paint, I didn't recognize it as my old shaft.

[@Assolan13]

pvc

[@_dybaIa]

pipe