Great review Gil! Hope you are safe in France with the SHTF over there. Stay safe and let us know if you need anything or a bugout location.
@RadioPrepper Жыл бұрын
Thanks, yes, absolutely nothing going on around here...
@kema3607 Жыл бұрын
结果约48,300,000个 very smooth!Rock & Roll !👏
@boonhargrove1399 Жыл бұрын
In your slicer start code, I believe you have to add M420 S1 after the G28 so the printer will load and use the saved bed mesh. We have the X2 and love it.
@RadioPrepper Жыл бұрын
Thank you! Like this?: G28 ; home all axes M240 M117 Purge extruder
@jimreed6503 Жыл бұрын
Love the reloading press on the bench. You really are prepared Gil. Thanks for the interesting videos. I often link to them in my ham column. 73
@RadioPrepper Жыл бұрын
Thank you!
@ShooterReadyStandBy Жыл бұрын
Nice printer. Reasonable price. I like the red 'accessory' on your bench 😉
@RadioPrepper Жыл бұрын
I bet ;-) I miss my Dillon 550B...
@timaustin577 Жыл бұрын
thank you :-)
@cindiali1457 Жыл бұрын
great review!
@phils2180 Жыл бұрын
It's not a bad price either,about the same as a good laser printer. I would have the same issue with finding somewhere to put it and leave it setup. Packing it away after every use isn't really practical. Looks like a good quality printer though.👍
@RadioPrepper Жыл бұрын
I got you guys a 50% OFF coupon, will post it in a few hours..
@dejedejsson Жыл бұрын
Hehe, and there artillery raised the price by $120, yesterday the price was $349 now $469, unfortunately I could not buy yesterday as my credit card was not topped up, which takes a banking day.
@RadioPrepper Жыл бұрын
Darn, there is the 50% off coupon, but that's ridiculous.
@dejedejsson Жыл бұрын
@@RadioPrepper Yes, sorry for you, no commission, will be an Elegoo neptune 4 instead.
@RadioPrepper Жыл бұрын
I don't get commissions on this one..
@williammorrison9045 Жыл бұрын
I'm getting a 404 error when I click the link for the printer.
@RadioPrepper Жыл бұрын
Darn, I'll check it out.. Thanks.
@RadioPrepper Жыл бұрын
Works for me..
@williammorrison9045 Жыл бұрын
@@RadioPrepper I just tried again and I still get the 404 error. I then copied the URL and tried a different web browser. It worked! Maybe "it" doesn't like Chrome browsers?