RGB LED matrix Display using ESP8266 | Morphing Clock

[@VPavan-fc1sz]

How to connect two rgb board can u tell me please 😢😢😢😢😢

[@haribalaji4136]

Hi Electro Point, I did the say thing as you did. But my ESP8266 is not getting upload, when I remove the pins from ESP8266, its uploading... Is there any problem with my p10 board? Its working perfectly in Arduino Nano

[@mostlyelectronics5304]

Sir, can you teach us daisy chaining of p10 rgb outdoor using px-matrix. I am using 32x16 display with 1/2 scan rate. It works well as a single panel, but when I am daisy chaining its not scrolling properly. I followed all the steps in pxmatrix github page and still its not working

[@davebeckham5429]

Very nice. Thanks for sharing.

[@ElectroPoint4u]

Thanks for your support!

[@rheksihermawan781]

@@ElectroPoint4u ll

[@trywatch1174]

thanks for sharing friends. I hope you make the RTC version

[@ElectroPoint4u]

The code for RTC version is available on github

[@mdaslamknl]

Good Keep it up

[@berbagibaik]

What is copatible with display led p5 rgb ?

[@ElectroPoint4u]

Yes

[@sajidahmed3137]

From where to purchase node mcu base

[@ElectroPoint4u]

If you want to get it cheaper I'd suggest Aliexpress or EBay