Factory Team Slipper Upgrade for Team Associated Pro2

[@jazzyjair]

If you are replacing the spring (which is also a good time to swap out for a new one to prevent spring sag and not holding plate in a constant orientation) when installing the new spring, tighten down so all coils are fully compressed or all touching, then back off to your preferred location then tighten fully one more time and then readjust to your preferred orientation. If you are using the same spring and want to maintain the same orientation, simply place a mark on top of the nut for an orientation mark, tighten fully counting the rotations in 90 degree intervals. Then to install reverse order then test then go RC'ing!!😁👍😁🗽Great video! A lot of people attempt to do these Noob-Intermediate videos usually flop them or give all wrong information but this video has it all. Great job Mang, keep it up!

[@RoadsideRC]

Thanks for the extra tips!

[@billyb5057]

looks a good upgrade to do *fully watched🥸💯Au👍left a like*

[@RoadsideRC]

Thank you 👍

[@countrycrawlers4713]

Great instructions how to do this! Thumbs up!

[@RoadsideRC]

Thank you!

[@thomasblair7996]

Great video, wouldalso be a good time to make sure everything is as it should be also

[@RoadsideRC]

Good point!!

[@BigKidsRC]

Nice how to video Troy thank you !!

[@RoadsideRC]

Thank you!

[@DanJr007_Collectibles]

Splendid video, crack 😊😊😊😊😊😊😊

[@RoadsideRC]

Thanks 😁