Where is a good place to buy cap top and damper for a roland XJ
@reprint2178 ай бұрын
Digiprint-supplies.com
@amymednick366121 күн бұрын
Great videos! How do you clean the ink lines at the damper end? I try to draw it out without the damper on and nothing comes out of 4 lines. (2 magenta, yellow and maybe light cyan) I replaced all my ink lines when I switched from white/silver to cyan/ magenta but I still had problems. Unfortunately, it sat for the last 6 months (kept getting error code 0109 and spotty inks). I have continued to keep the head soaked so I believe that is fine, I do not have the choke installed any more ( the tech when he replaced the lines disconnected it) but all the parts are there if I need to reconnect.
@reprint21721 күн бұрын
Have you pulled your lines from the ink needle? Possibly the needles are clogged in the cartridge bay
@reprint21721 күн бұрын
Also, I have had machines with the choke valve bypassed, have seen this many times and be very careful when messing with the head. I choked one off and assumed it was choked and destroyed a brand new head.
@amymednick366121 күн бұрын
@@reprint217OOOHHH! I never thought of that!! I will check. Thank you!
@amymednick366121 күн бұрын
@@reprint217 unfortunately I do not have anything small enough to go over the needle. Do you have a suggestion for the tubes that attach to the damper top?
@thekopyshop73502 ай бұрын
Hi there, I have a roland XR640. Yellow just drop off on one head, all the other colours are like new... Had damper changed. No difference. Any suggestions? It was fine during a print, then it drop off on the next set for about 2 lines of stickers, then came back 100% on the 3rd line and then on the next set it just stopped again. No yellow on the damper after normal cleans, yellow comes thru little on the powerful clean, but no yellow at all on that head on test print.
@creativesignsolutionsinc.5866Ай бұрын
I am having the exact same problem on the #4 Magenta Channel. Just stopped and showing sections in the ink tube with no ink.
@thekopyshop7350Ай бұрын
@@creativesignsolutionsinc.5866 urs may be ink starvation issue. Have u at any point bent the clips on the ink cartridge just to finish a job in an emergency then put a new cartridge the next day?
@reprint217Ай бұрын
Send me pic 217-413-2532
@reprint217Ай бұрын
Sens pic 217-413-2532
@jonathanelam2331Ай бұрын
no I've never done that. I actually identified and solved tbe issue. the choke valve went bad and I just bypassed it...
@estebanhernandezfernandez12786 ай бұрын
I have one problem in my Roland VS540-i. The head has already been replaced but it still has problems with the black line, have you had a problem like this. I thank you if you help me
@reprint2176 ай бұрын
Story of my life. When replacing a head, it either goes smoothly or terribly wrong. Sometimes its aftermarket dampers, they are hit and miss. Choke valve issue, ink tubing getting air... so many possibilities. It's really just narrowing it down.