Rusty 1974 Porsche 911 Front Pan Replacement - Part 1!

Now that the floor is completed (progress documented on Instagram and TikTok) - we dig into the front pan.
Instagram: / cruciblecoa. .
/ kraws
TikTok: / ryankraws

[@angeloc700]

Thanks for making this, and nice work. “The Jig” is great. I’ve been thinking about an upcoming project, and will use the idea. Thanks again.

[@garagebeers1]

Great work as usual

[@malcolmbindon5911]

Nothing better than drilling out spot welds 😄👍.

[@CrucibleCoachworks]

The woooooorrrstttt

[@malcolmbindon5911]

@@CrucibleCoachworks I used these bits that had a spring load locating pin and the cutter was like a 10mm dia hole saw . You would cut around the spot weld and only go through the top panel . Once you removed the panel you would just grind the lower panel flat . Cheers Mal

[@CrucibleCoachworks]

@@malcolmbindon5911 yeah we have a set of those! I found them to be the best as well, although I often use the belt grinder also. Cheers!

[@JonFukuda]

Did you ever document the rest of this job in posts? TikTok or YT?

[@hiflyer9568]

Approximately how much should it cost for a job like this? (Replacing the front pan as done in these videos)

[@polloloci21]

I remember doing this a while ago. It would have been so much easier if my car was on a rotisserie. Haha.

[@hillbilly-engineering]

Thanks for making this, I'm getting ready to tackle this and seeing how you approach it is helpful. Did you purchase that jig or build it yourself? Also, the floor pan looks fresh, did you replace that as well?

[@desmomotodesmomoto2033]

What happened to this build? any updates, or only on Tik tok.

[@paf_ka9527]

Просто ауфь, братан

[@markd7923]

would you consider selling/renting that jig? Dm sent thru ig