RV Tester For 7 Way and Slideouts

[@jamespooler8809]

I'd have to say yours is the best I have seen yet. I am in the process of building one fairly similar. I have all the components, now I have to come up with the time to put it together.

[@usmcmoose90]

You need to patent and sell these tools. I need these yesterday😀

[@glmorley]

Just what I was looking for…building one now using wireless remote controller.

[@mikmaster63]

I work on a lot of slide outs so I like being able to be close to the components while diagnosing. My boss doesn’t like the techs helping each other so I had figure out a way to work solo…

[@nwright28]

Wish I could have the parts list, so I can build the trailer tester. I have a supervisor who is not friendly and makes my job harder to work on the trailers. 😢😢

[@mikmaster63]

@@nwright28 kzbin.info/www/bejne/iYPbZYWworODjtUsi=xGhUZGLyyJ-NEpK3 I don’t have an updated parts list. Some of the parts become unavailable on Amazon and you have to search out replacements. There are also shorter videos. Step by step on my page…

[@mikmaster63]

@@nwright28 kzbin.info/aero/PLVUpxshDPOIGc_ZTNDXCj_ZfzxI2hfO5K&si=-vpbPuzn4dQdgkJc

[@chrisendreshak3980]

Are you selling these? If so, where can I get one. If not, why not? I know at least 15-20 RV Inspectors and Techs that would love to add this to their toolbox!

[@mikmaster63]

Patent is expensive…

[@prentissmcguire126]

I'm an rv tech and I would love to pick your brain on the box you made

[@mikmaster63]

Working on a new box that combines the wireless and the slim rack tester. What would you like to know.

[@prentissmcguire126]

@mikmaster63 I would like to know your build steps because I've seen a few on here and so far I like your set up the best and I have alot of the hard wire components already but I want to make my box wireless as well

[@mikmaster63]

I’ll have a new video finished on the slide out tool soon. Not sure if it will include wiring diagram or if I’ll post them separately. The diagrams take me a while to do. As far as the 7 way tester I haven’t decided if I will make video on that. I have years into designing it and it’s a little more difficult and time consuming than the slide tool.

[@prentissmcguire126]

@mikmaster63 well if you do decide to I would love to no when that video drops. I do alot of slide out work and quite a bit of pdi at the shop and your setup would probably drop my times in half on some jobs

[@TexasBackyardFarmer]

Do have list of components? Specifically the battery amp meter voltage meter two-speed flasher relay

[@mikmaster63]

I think all parts were purchased on Amazon. At the moment I’m not giving away how I built it. Possibly going to sell them…

[@TexasBackyardFarmer]

@@mikmaster63 I was just worried about the quality of the parts. I do not want to build it multiple times because of bad parts

[@mikmaster63]

Boy howdy, I had a relay board that was terrible so I built my own and the 1st voltage meter I used was terrible also. The rest have been working fine. I have years of testing and redesign invested in this thing…