Join SBT PWC tech pros, Jose and Mat to learn how to rebuild your jet ski supercharger step-by-step.
Пікірлер: 22
@scottlucas12748 жыл бұрын
anybody who follows the steps in this video is asking for problems...You press the bearings on the shaft AND into the housing BEFORE you put the seal thrust disc in..REASON: the bearing behind the seal can and does push out when you press the shaft into it..Also you tighten the impeller nut first as if you dont...the clutch thrust assembly can spin on the shaft blocking the oil hole....Also you DO NOT use grease when assembling the supercharger..You want to use OIL...NOT grease.......Like i said..follow these instructions and you will be replacing your Scer and or engine ssooner than later...
@BMJAUDI4 жыл бұрын
Do you rebuild these SC'ers? I have mine removed and am looking for someone to rebuild it.
@kensmith88869 жыл бұрын
Good video, best one I seen yet.
@garygarnett64692 жыл бұрын
What happened with checking the clutch slippage
@renefontanez15314 жыл бұрын
Yeb, one important part was miss ,the one im looking for ,
@adist.36276 жыл бұрын
Are these metal washers or crappy oem ceramic ones?
@marceldeleon12453 жыл бұрын
Hola cuantos nm se apreta el tornillo y porque acer lo del piñon para que silve ? Gracias
@jefftougint63286 жыл бұрын
What is the failure rate for the shown Bearings and clutch washers? They don't look OEM whatsoever..
@TheKickBeck8 жыл бұрын
how to you check the slippage of the clutch? thanks
@brandenerwin26856 жыл бұрын
he put enough rtv on to rebuild a 4 tec engine
@swatcat79282 жыл бұрын
What boost does the supercharger do?
@schajbi8 ай бұрын
can i ask a question IS IT NECESSARY to balance sc after replacement?
@SBTengines8 ай бұрын
Please email tech@sbt.com
@Markb-cg5dy8 жыл бұрын
I am going to order your kit but am wondering if I need to have the new shaft balanced at a turbo shop locally.
@SBTengines8 жыл бұрын
Hi Mark, Did you contact our tech department?
@Markb-cg5dy8 жыл бұрын
My son emailed sales@shopsbt.com twice but hasn't received a reply.
@SBTengines8 жыл бұрын
I am sorry you had that experience. Our kit is plug and play, no additional machining needed.
@eostrow19638 жыл бұрын
should the supercharger flywheel have zero play whatsoever?
@martinperea4968 жыл бұрын
useless video, im a master tech SeaDoo , please do not follow what they say , that is not the way to rebuild a Sc
@nebraska402madden44 жыл бұрын
Hey question. Im changing washers on mine sc and everyone is stacking them like this )()() but rive directions said to stack them like this for more friction)))() ,,is that really way to go??