thank you so much for not having loud annoying music!
@jortega2229 жыл бұрын
I liked the video, it's self-explanatory!
@kaducostavale3 жыл бұрын
Perfeito!! 👏👏
@nn-js4yg8 жыл бұрын
Thanks great video.....
@atheerismail18389 жыл бұрын
Great video
@baldysroost57579 жыл бұрын
A little commentary of what is going on would be helpful. There is no explanation of why or what you are doing to go with the video. I guess if you are a mechanic already, this would not be helpful. Do not understand why there is not a voice explaining what you are doing and why.
@ddiana9774 жыл бұрын
bel video ma dovresti controllare con chiave dinamometrica la taratura della frizione dell'alberino
@derargentinier8879 Жыл бұрын
Exelente video 👏
@MrEvandroxd4 жыл бұрын
👏🏽👏🏽👏🏽
@Gmtail8 жыл бұрын
I've never seen those brand hand tools before.. What are they?
@TheKickBeck8 жыл бұрын
how do you check the slippage of the clutch?
@talusranch9905 жыл бұрын
You don't need to...... Ha
@eostrow19638 жыл бұрын
so the supercharger flywheel should have no play whatsoever back and forth?
@VultchInc2 жыл бұрын
Correct
@marceldeleon12453 жыл бұрын
Cuantos nm se apreta el tornillo ?
@glacier_official60017 жыл бұрын
This is NOT a very good video. No explanation at all. Its only a good video if you already know what you are doing. Beezness needs to do a voice over explaining what the heck he is doing.
@lucabacci62395 жыл бұрын
Lukely is not my supercharger, bearing wrongly installed and torque wrench is usless on that way... i hope it didn’t fail after few hours..
@Tassie19667 жыл бұрын
Do you realise that you have the bearing around on the wrong way on the shaft ?
@kenmanser9596 жыл бұрын
And someone should tell him that when your torque wrench clicks that's when you stop! Unless it says Walmart on it.
@pauldeanmotorsports79913 жыл бұрын
He made a few mistakes not just bearing
@wmabde02 жыл бұрын
I agree he did make a few mistakes. One of which is you don't apply gasket silicon loop around the bolt hole, if you expect it to seal tight.
@darnice11255 жыл бұрын
Wathcn 10 min and realized this guy is a hack, Watchh the 3Ft Deep video instead, its done correctly there!
@pauldeanmotorsports79913 жыл бұрын
Lots of mistakes made
@florytolino39218 жыл бұрын
no he's telling you to send your supercharger to him so he can fix it because you will just f*** it up . they're all specialty tools just for that supercharger and nothing else . one job I do not want to do
@fakegibsonssuck77558 жыл бұрын
You can order them through the dealer, hardly special tools....
@talusranch9905 жыл бұрын
Repleat with mistakes and hacks
@traviswagner98226 жыл бұрын
camera angle is awful
@MB-ib7pl6 ай бұрын
Horrible video but IF you are mechanically inclined it’s enough to get an idea