schumacher cougar 2 works K216 U8950 Driveshaft,U8946 Body,U8947 Mouldings,U8931 Rod,U8798 Bearing

[@elfredo2065]

I had the exact same issue and I also used a socket driver to push them into place. Didn’t use a hammer though. The method is also helpfull when assembling the circlip-part on the old Procat or Cougar shocks.

[@ChannelVSRC]

@@elfredo2065 Thanks for watching 👀 🙏 I just could get the black plastic bush in just by pushing 🤪 I also used my 5.5 drive to push in the shock seals 🤮

[@Teck-N-stuff]

Lol same here ! Ive nick named my car Andrew 😂 due it being a royal pain in the as* 😮 great channel ive followed you from the start, keep it up. 👍

[@ChannelVSRC]

@@Teck-N-stuff Very kind 😇 Thanks for watching 👀 🙏 How Andrew doing? Finished your build ?

[@carlomac]

Also noticed that when fitting the very small after market ball bearings that if you crimp down too hard, they will not roll easily, so just check that.

[@ChannelVSRC]

@@carlomac I know one needs to be very careful with these tiny rollers

[@jecoboost1440]

I use a 5.5m driver. It worked 😊

[@ChannelVSRC]

@jecoboost1440 thanks for watching 👀 🙏 one needs to use the correct tool 🥳 5.5 fits a treat

[@modelRcnoob]

Guy 😂 yes my build is following yours, Took me a while to get them plastic parts in place 🤬🤬🤬🤬 thanks for the share.

[@ChannelVSRC]

@modelRcnoob Thanks for watching 👀 🙏 Same batch ? Finished your build?

[@cndvehicleinspections8313]

Black oops lol stealth issue 😮 yes you can hear the pop at 16:00 pop in place, i would say. Thanks for the share. I've not built my yet 👊

[@ChannelVSRC]

Thanks for watching 👀 🙏 oh yes, it's loud, init.

[@brannmitchell4602]

Yep, same issue here. It took me a bit to figure out what was not happening, and also used a 5.5mm driver to seat them. However, I'm 99% sure my (USA) kit came with bearings (green dust seals) and not bushings for the slip shaft. Considering the challenge of assembling the driveshafts, I'm not about to tear them apart to find out :D My solution for the yokes was to heat them over the electric stove. Smooth assembly after that

[@ChannelVSRC]

@brannmitchell4602 Thanks for watching 👀 🙏 with the amount of issues with kits it wouldn't surprise me if you had premium rollers in your kit 🥳 bonus lol next video shows the pain of fitting universal driver shafts joints with no heat just painfully fitted