Scotty Anchor System on an Inflatable Boat (Installation and Use)

[@FTOTF1]

Im going to try this one just need to find something for rope management. Thanks for the vid very helpful

[@DavidPhamChannel]

Glad it was helpful!

[@alzayas6666]

Love it, great system, thanks!

[@DavidPhamChannel]

Glad you like it!

[@Snowboardbound]

Genius! Thank you!

[@DavidPhamChannel]

No problem!

[@newhavenchristianministrie6721]

Excellent

[@HansRiveraCreations]

I have a smaller 1.5 kg graple anchor. Do you think that it will be enough to keep my boat from moving or should I get a bigger anchor?

[@DavidPhamChannel]

It depend on many factors. How big if your boat? Wind conditions? Most importantly what kind of substrate is there at the bottom of the lake/ocean? Grapler anchors are meant to cling on to rocky bottoms so they don't need much weight. If you are boating in an area with sandy or muddy bottom the grapler anchor will not hold. I use a grapler anchor myself but its pretty heavy plus i have a chain on it. I boat in a variety of areas and find this setup pretty universal.

[@HansRiveraCreations]

@@DavidPhamChannel yeah I have a chain on my grappler that’s being used on my seahawk 4, my lake has patches of rock and sand but based on what you are saying I think I might upgrade to a bigger and better anchor. Thanks for your help

[@MrMattie]

What position on the boat do you recommend putting the anchor system? in front, side, back? Thanks

[@DavidPhamChannel]

Front, the boat will have less drag when anchored thus keeping you in place better.

[@jimmywallhanger8402]

Hiw many feet of rope and what diameter? Thanks

[@DavidPhamChannel]

I don't quite recall, 30 feet in length maybe, not sure on the diameter.

[@angelamelrose7474]

Do you remove it to fold up

[@DavidPhamChannel]

The anchor assembly comes off but the patch/mount stays on. Folding the boat with the patch and mount isn't any different than without, its pretty small.

[@bert3195]

Really helpful, thanks! Would a 15 lb anchor be too heavy?

[@DavidPhamChannel]

Really depends on the lake bottom material, type of anchor and boat size.

[@bert3195]

@@DavidPhamChannel I mean for the mount. Would it be too heavy for the glue?

[@DavidPhamChannel]

@@bert3195 I really dont know, i m using a 10lb one myself and its totally fine. Since its the same glue they are using for the handles on the boat i would imagine it to be ok since the handles are meant to support the weight of these boats (~100 lbs).

[@bert3195]

@@DavidPhamChannel Where did you get the glue? Seems to be pretty hard to find the glue Scotty recommends in Calgary.

[@DavidPhamChannel]

@@bert3195 Automarine specialties

[@guyak65]

Which PVC Glue do you recommend ??

[@DavidPhamChannel]

Sorry can't recommend any, had my local shop install the patch.

[@flypike22]

Bad idea. The anchor/rope rubs against the boat. The rope is run too close to the pontoon. The PVC material will quickly get damaged. Great example: kzbin.info/www/bejne/lZmUmZKdhrGGjtE

[@DavidPhamChannel]

Good video, so far I haven't noticed any wear on the boat but I probably don't use the boat as much as id like. Definitely something to consider