Scrap Wood Egg Tray | Pallet Wood Project | Egg Holder Design | Woodworking

[@larrystone5749]

Good job and project thx for sharing enjoyed it

[@happywoodworking]

Thanks for watching!

[@tonywebb3867]

Cool Project!

[@happywoodworking]

Thanks for watching. Happy Woodworking!

[@tomt9543]

Cool idea!

[@happywoodworking]

Thanks for watching.

[@danalaniz7314]

Great project Ya'll! Well thought out and simplistic/functional design. The round-overs on the individual egg holders were a great idea. the mineral oil finish really brought out the beauty of the maple. Thanks!

[@happywoodworking]

Thanks so much for watching. Happy Woodworking!

[@larrystone5749]

How did you figure out where the holes went

[@happywoodworking]

Thanks for watching. I guess we didn't show that in the video. Sorry about that. I think we measured in 1 1/2" from the edges and drew lines down each side. Then drew lines across the width every 2 inches. Where the lines intersect will be the center of each hole. Happy Woodworking!

[@larrystone5749]

@@happywoodworking thx

[@jimgummere5561]

How thick is the wood? 1/2””?

[@happywoodworking]

It started out at 3/4". Then I planed it down to 9/16". But, the thickness can be whatever you want or need. Happy Woodworking!