Screwfix - Rawlplug RawlBolts

Screwfix - General purpose anchor bolt. Ferrule marked with hole for correct installation. Use in concrete, brickwork and stone.

[@blvckAveli]

Ive noticed knocking in the plufs without any bolt inside most of the times knocks out the springs as their is no tension init.. I advise you screw the bolt in to the plug and then knock the bolt amd plugs in

[@walterblanc9708]

So what size drill bit do you use? How much bigger than the Shield/case diameter? How much deeper than the length of the bolt do you drill. So many different sizes these days.

[@SokdyPham]

When I left Vietnam for nearly 2 years, the company did not return the insurance papers to the workers

[@assemalmostafa4805]

هل يمكن استخراجه بعد انقضاء الحاجة منه ؟

[@richiefinn]

What size drill bit?

[@bluealf33]

Depends on what size rawl bolt use the same as the bolt size so 10mm drill for 10mm bolt etc

[@heroknaderi]

I appreciate your video thank you for your time 😎

[@olurotimidaniel3968]

Ssssßssssß

[@muhammadiidentity3476]

How much price of pack

[@aniljadhav1141]

What did you use to clear dust from that hole at 0.08? I want to know the name. I want to buy. Is it electric device or mechanical device?

[@CantEatRS]

probably compressed air but you can just use vacume

[@killermurderer2208]

Football pump with straw

[@zigzag7194]

I would of liked to see how you remove it.

[@RZVPeter]

You just unscrew it and it releases its grip.

[@MarkHopewell]

Take off the nut at the end, then knock the thread in gently until the anchor section of the bolt loosens from the surrounding brick. Then wiggle the anchor free until it comes out of the brick etc;

[@SokdyPham]

The company's human resources also take money from workers' sick pay. refuse to pay.

[@psycheevolved1428]

Don't use them! There's no need at all.

[@muntare1]

Why not?

[@RZVPeter]

What do you recommend?

[@muntare1]

@@RZVPeter I too am curios as to why we shouldn't use them.

[@colindavies9971]

can use concrete bolts now,,,no plug needed ,,, just drill hole,,, with 8mm sds drill bit,,,then use 10 mm bolt, or whatever size you require ........and it taps its own thread as you drive it in,,,,,and can be taken out and reused in same hole,,,,,easy ,,and solid hold