Sculpfun S30 Ultra 33W - test and review!

[@maryseidl8081]

I can't imagine a better explanation for a laser device. Great examples~test work! 👌👌👌

[@mawi3113]

Thank you for your explans, like always. There should be more such „honest product tests“ like this on youtube. Looks like my new laser device. Pls go ahead. 👍🏻

[@EliseiDesign]

6:59 not perfect at all. Most of the teeth were jagged !!

[@snuj5611]

What is the thickness of all materials? A test like this absolutely useless without the thickness of each materials!

[@heikoofalltrades2267]

@@snuj5611 For my understanding the max cut performance with one pass ist not that important as I more like using less power and more passes. Is better for the diode. Next is the cutting speed. I can take 100% power and move the laser extremly slow. Yes I can cut very deep but you have a lot of heat and burnmarks and the danger of fire is higher. In my experience the laser can safly cut 10mm ply with one pass but I had 8mm ply where this was not working with the same settings. It realy depends on the individual material YOU use. Other test stated it can cut 18 mm pine in two passes. I tryed that for fun but it never worked with my wood here. I wanted to give you an impression of the laser performance in my video but I cant give numbers for max material cutting power. All usual materials 4 to 8 mm are easy to cut.

[@snuj5611]

@heikoofalltrades2267 I just wanted to know the settings and the thickness together. That would have been a good comparison for me because I have the same laser even if all materials are a bit different. Anyway good video!