Sculpting Elegance: Onyx Signet Ring Jewelry CAD Design with Rhino 3D - A Step-by-Step Guide

[@voulazarpani7688]

Great tip about moving the point where the split of the curve will commence! And of course the fillet at the end makes everything looks so "finished" and polished. Thank you very much. It is always so satisfying to see such nice surfaces created with Rhino :)

[@PJChenJewelryDesign]

Happy to know you enjoy the video!

[@MasoumehGheblei-ek9uo]

Thank you PJ...It's very helpful 😊

[@PJChenJewelryDesign]

Glad it was helpful!

[@humbertocastillo9439]

Excellent thanks PJ

[@PJChenJewelryDesign]

Very welcome

[@모리-k4r]

great! thanks for various tips. Your videos are also helpful for those learning advanced courses.

[@PJChenJewelryDesign]

Glad to hear that!

[@miriamm5076]

Thank you! This video helped me a lot.

[@PJChenJewelryDesign]

Glad it helped! thank you for your support!

[@alainbrochet5610]

Toujours rationnel et compréhensible !

[@PJChenJewelryDesign]

great. thank you

[@martinpontbriand8048]

Thanks PJ

[@PJChenJewelryDesign]

no problem!

[@eliudegmdialamicua6169]

❤👌

[@PJChenJewelryDesign]

Thanks

[@thomail]

Nice!!

[@PJChenJewelryDesign]

Thanks

[@RonAdamsky]

Before Sweep2Rail and after Dupedge I had to do join curves to correct sweep.

[@dusanrajh5025]

Thanks

[@PJChenJewelryDesign]

No problem

[@NiceTower]

👏👏👏👏

[@PJChenJewelryDesign]

Thanks

[@RajeshSimpaVlogs2005]

wow

[@PJChenJewelryDesign]

Yeah.

[@luis_escobar..]

Can i get a work in USA

[@rirarari1887]

Hey PJ, if I want to make this ready for printing but I want the stone to be set, do i need to add extra material for the setter?

[@PJChenJewelryDesign]

If you plan to have bezel set, Yes. If you plan to have inlay, No

[@rirarari1887]

@@PJChenJewelryDesign so let's say i offset an edge around where the stone will sit and extrude that for 0.25/0.5mm high. would that be enough?

[@mohammadnasir3786]

PLS FOXTAIL CHAIN UPLOAD