SE SPORT 400 Hydrofoil INSTALLATION VIDEO

How to install SE SPORT 400 Drill Free / FAQ /

[@willbrink]

Just ordered that for my Whaler 130 super sport and will view when I get it for install.

[@Fishing-Texas]

This thing made a huge difference on my aluminum boat. Highly recommended.

[@joeshwetz5901]

Guys for a little extra security , I install a brace underneath with to short pan head screws from the trim tab to the hydro foil ,works for me haven't lost one yet !! About 4-6 inches long ,maybe more on bigger engines . A thin flat bar or the strapping you use for securing plumbing , you get the idea . It's underneath so you won't see it or paint before you install if you want !!

[@guessorwho]

I have the SE 300 on 150 yamaha engine more than 5 years and works perfect. Now I install the SE 400(drill free) on 225 mercury optimax and after 10-15hours of use in one month LOST IT ON THE SEA!!! They must redesign it.

[@MrXr8260]

Excellent video

[@jpbernie72]

My 300 stayed on for almost an entire season only to fall off. My 400 immediately slipped back approximately 3 inches after a couple of runs at speed. I re-tightened it after the first use only to find it slip back 3 to 4 inches again. If I tighten the bolts anymore, they will break (which happened to one of my bolts during my initial installation). Any suggestions? I really would like to keep the hydrofoil on; however, I’m literally throwing my money away. Thanks for any advice you may be willing to provide. Jim

[@boatsportperformance]

James Bernthal James, there were some Sport 400s shipped without clear instructions on the position of the 2" rubber washers. Also, some of the rubber was too hard for a good grip on the bottom of the cavitation plate. Check to make sure the rubber washers cover the "step" on the top of the Disk-Grips and don't hesitate to ask us for the softer rubber washers. You may contact us through our web site, www.sesport.com. Thank you.