Sears 3 point hitch on craftsman gt 6000

Sears three point hitch on a Craftsman GT 6000
#Gardetractor
#Repair
#Gardentractorfrontendloader
#Lawnmowerrepair
#DIY
#CarryAll
#CraftsmanMower
#Wheelhorsegardentractor
#JohnDeere
#mowerrepair
#smallenginerepair
#lawnandgarden

[@jafinch78]

Nice build! Looking forward to doing similar for a Sears Craftsman rototiller from a SS16 and other rear implements eventually on the Ford YT16 and John Deere 240 custom garden tractors. Thanks for sharing! Appreciate that.

[@MurphyMower]

I did another video where I swapped the actuator

[@jafinch78]

@@MurphyMower Thanks for the heads up. I'll take a look at your channels and see what I find. Just put up a car port HF thing to work under this season to get out of the sun, rain and snow to move forward now the cooler weather is starting. Been so busy, I've not done anything but get the YT16 up on a roll around dolly to prep for fabricating what I'll need to get the White GT185 hydro rear end fit and functioning. Then will be more custom rear end work.

[@MurphyMower]

kzbin.info/www/bejne/aaOudXxpd9h1bNk

[@darrellwofford3297]

how much down presser does it put to ground ,very good video

[@MurphyMower]

There is no down pressure on this it’s just the weight of your implement, thanks for watching

[@tommymurphy6103]

Will a older craftsman hitch with a Handel fit on a newer craftsman Gt 5000

[@MurphyMower]

Have not tried that-there’s a lot of different manual hitches I’m sure one would work

[@craigalston2208]

@@MurphyMower what is the stroke of the electronic motor for the hitch ?

[@MurphyMower]

@@craigalston2208 I believe it is 4 inch

[@MurphyMower]

@@craigalston2208 I have another video on my page where I upgraded to a newer linear actuator that is a 4 inch stroke that works very well

[@jonathanolsen7254]

Do you have another 3-point elect hitch you want to sell?

[@MurphyMower]

I may but the motor will not be dependable- you would need to upgrade it

[@MurphyMower]

Like this kzbin.info/www/bejne/aaOudXxpd9h1bNk