Sena 10U Bluetooth Module installation into Arai Chaser X Helmet

My first KZbin video folks....don't shoot me please. After less than brilliant instructions from Sena and Arai on how to fit the 10U into my helmet, decided instead of complaining about it, to do something positive and make a video. Features my living room floor and fluffy carpet.
Please leave your comments below. Hope you find it useful.

[@ilup7376]

Nice video, helpfull! Thanks! I completed installation. Good luck!

[@davidsmart40]

Good video. Might try and instal mine now. What sena don't tell you when buying the 10u for an Arai is that your Arai helmet must be one with a removable neck roll. A lot of the range including the helmet I bought the comms for have fixed neckrolls. Do you find it easy enough to find the charging point with it being inside the helmet?

[@maxeaves]

Hello David, The charging point is a little hard to find, but since I have a helmet stand, it's made it easy. Rest the helmet in the stand and turn the helmet upside down and connect it up for recharging.

[@TomDrummer95]

Hi Max. As a result of you fitting the new Sena, is there a big difference between where the neck-roll sits at the back of the helmet? Looking at the video around the 20:40 mark, it looks like there a big gap between where the neck-roll is and where the back of the skull cap part of the helmet starts. Does that make sense?

[@maxeaves]

Hello Tom. The neck role is ever so slightly higher but not noticeable. Make sure that when you put the module at the back of the helmet that you didn't push the retaining clips behind the helmet cushions, instead of between the two parts of the back cushion. Let me know how you get on. Email: maxeaves dot me at gmail dot com if you are still struggling with some photos. Thanks