Setting Reference Using APC Test Reference Cords on the Fluke Networks CertiFiber® Pro

In this video Mike Pennacchi of Network Protocol Specialists, LLC demonstrates the process of setting a 1-Jumper reference using APC Test Reference Cords on the Fluke Networks CertiFiber® Pro.
LC/APC Fluke Networks Test Reference Cords - amzn.to/3M13oGa
SC/APC Fluke Networks Test Reference Cords - amzn.to/3K3CGft
For information on certification training, visit:
cctttraining.com

[@markakrellcom3184]

Excellent video instructions. Thank you! 😊

[@danielaguirre3490]

VERRY helpful on fiber terminations 😤🚀🚀🚀😤😤

[@SeihingSei]

ต้องการให้แปลให้ภาษาไทยครับ

[@kylebaylor4226]

Can you explain explain what to do if your TRC values come up negative?

[@MikePennacchi]

Negative TRC Verification values are typically caused by not waiting long enough for the modules to warm up. As they warm up the power output increases. It is best to wait 5 minutes after turning them on to set reference. Another cause can be having the TRCs coiled up when you set reference, then uncoiling them to do the TRC Verification. The coils add loss that is removed when they are uncoiled.