Excellent!!! Love those close ups, sir, very much appreciate your detailed video! 👍👌👏👏
@adasdown2earthessentials1866 жыл бұрын
Thank You so much!! I was melting my brains triying to treathing my machine I almost give up but I decide to go to KZbin and look for help and You did,thank You!! Thank You!!
@hyperboly5 жыл бұрын
Thank you so much, this helps on my Kenmore 159!
@edriquez573 жыл бұрын
Thank you in 2021
@hitoortega16162 жыл бұрын
Excellent
@MrKnottin11 жыл бұрын
Thanks!!!
@juliabrown53965 жыл бұрын
Thank you😀
@volgadeutsche3 жыл бұрын
My pressure lever is loose, it won't raise/lower the pressure foot. How can I fix it? White/ Kenmore Rotary.
@sandrapurnell14807 жыл бұрын
Do you have a video on the assembling the tension on a FR Rotary 2527373? I recently bought one fro a thrift store and the tension piece was taken apart, I am hoping all the pieces I need are in the bag they provided. Any assistance is greatly appreciated.
@tombrown34197 жыл бұрын
No other videos on that, I have not looked at it in a while. Check out this, it may show somewhat how it goes together. they are very simple and a bit intuitive on assembly
@jafinch782 жыл бұрын
There is this video regarding the tension assembly on the White FR: kzbin.info/www/bejne/lYCnXqNnobuKarc When I get around to, might try... though so far everything with my head face cover off seems in spec. on all my White's.
@shelliematter25035 жыл бұрын
I have a 40s white machine and I can NOT get the bobbin to thread. I am loosing my mind trying to figure out how to get this machine working.
@edriquez573 жыл бұрын
I had the same problem. I got it to catch by turning the needle a little bit off center, and it caught the next time.
@jafinch782 жыл бұрын
Verify correct needle, threading is correct including down to the needle where if these White's from left to right where the flat side of the need shank is on the right side. Possibly needle is bent. Also, the most humorous to me was turning the balance wheel the correct direction. Set your stitch length to the longest setting and verify based on the feed dogs direction. I had to replace my needle and then after rethreading correctly and videoing, I realized I was going in the wrong direction. I also have a video, see "Update 4.5" where I had to thoroughly clean the bobbin shuttle and race area.