Shaper Plate Applications

[@HelloAnthony]

For my future reference: 0:04 - Engraving a logo 3:54 - Sys 32 Shelf Pin Holes 8:11 - Corner Rounding 13:25 - Soss Hinge 15:55 - Brusso Hinge

[@teac117]

That "retract bit tip" sounds like one of those 'ask me how I know' tips ;)

[@brianmosse]

What ever you did to stop your errr. speech impediment you have achieved allot good on you mate . And a great teaching vid. My plate is on order.

[@teanau3]

Hats off to the edit team.

[@TowerThree]

Would like to see a video detailing the 32mm hole use case. Should cover getting the holes at 37mm from the edge and continuing the hole pattern to, say, 12 holes.

[@MORTIFyER666]

@shaper: I dont find the corner rounding files on shaper hub?

[@teanau3]

ill get them up to you asap

[@80211Denver]

Can't wait for mine to arrive! Ordered first day available.

[@TheOneLin3]

With the 5 holes, what if you want holes over the total length? Can you move the plate then? How to align the plate then with the already cut holes? 🙏

[@davesmulders3931]

Just make multiple pencil marks a plural of 32mm apart. But then again.... if you need to make a lot of these holes the LR-32 system of Festool is way easier and faster.

[@jonathandcohen]

@@davesmulders3931Seems like the obvious solution, but then you are back to human error in alignment. It is one thing to use a pencil mare to center, it is another to rely on that for hole-set to hole-set alignment... with Origin, you would expect that to be machine exact!

[@davesmulders3931]

@@jonathandcohen True....however if you make some kind of jig to align the template to previous hole-sets, you will stack the error in the template multiple times. If you mark out the cutting locations in one go to the reference plane, then you will most likely be more accurate. The option you have with origin to do this exact is to stick some long pieces of Origin tape to a board and just make a full size workspace. Align once, cut all the holes. You do not use the plate then obviously. If it needs to be repeatable work, you can cut an alignment template for the plate-stops which you add to the board to be cut. There are ways, but I'd just mark out my locations and eyeball a close to perfect alignment. Close is often good enough.

[@sandyfisher2618]

So maybe I missed it, what is preventing the bit from cutting into the plate? What if you are using a larger bit?

[@andrhamm]

Nothing

[@dawsons.3675]

This is WAY too clean...you guys from the future?

[@waytospergtherebro]

It's the best way to waste hundreds of dollars on a piece of phenolic that will never make your grandchildren love you.

[@friendlymaendi]

Why wouldn’t they love you for having showed and let them use your Origin?