Short Boring Video

[@EverettsWorkshop]

That's a nice setup, even with a ready-installed chip catcher underneath! Very cool.

[@swanvalleymachineshop]

Nice one Ken . You have a good radial drill there .

[@outsidescrewball]

just luv the radial arm drill unit…..nice

[@captcarlos]

I was hoping to see the Horizontal all set up but you work with what ya got. Set up looked great, no chatter heard. Looking forward to the HBM..

[@stovepipe666]

Looks to be cutting well

[@TrPrecisionMachining]

good job

[@sambrose1]

Before I read the discription I was like that looks like the radial arms at work.

[@Rustinox]

Well, that's something you don't see every day.

[@jeremycable51]

Hey could you show a kinda how to on setting up to bore with the radial arm drill there’s no good videos on it

[@andrewdalgarno5322]

My ATW Radial is like that!

[@DolezalPetr]

sounds nice

[@hilltopmachineworks2131]

Inventive to say the least using a RAD to do the boring.

[@hmw-ms3tx]

I've used this radial drill to do quite a bit of boring, especially before I got my horizontal mill. This particular drill came with the boring option that was available from the factory. It's just a lever and when you move it from 'drilling' to 'boring' it cuts the feeds by a factor of four. It gives as low as .001" per rev which can give a pretty nice surface finish.

[@josephwaldner7752]

Wow that's boring :)