Shure SM58 Myths 3 - Feedback

When feedback strikes, the microphone usually takes the rap. But feedback isn’t all the mic’s fault. In this video, Chad Wiggins comes clean, and reveals that feedback is an acoustic conspiracy.
To learn more about the SM58, visit: www.shure.com/en-US/performan...
Follow Shure on Facebook and Instagram:
/ shureinc
/ shure
#Shure #audio #sm58

[@jimgrill]

It’s a hot mic. Adjust accordingly. That’s all. If a small room and high volume is unavoidable, try an audix om-7, but you will have to put your mouth right on it and sacrifice mic control techniques. It will require a lot more headroom to overcome its low gain. Otherwise the sm-58 is my first choice.

[@SubiFoa]

I have one and it produce a lot of noise , what can I do to solve it out ?

[@drcl7429]

First, it might be a fake, second if you are getting a lot of noise, its most likely a faulty or unbalanced cable. Third, what are you plugging the mic in to - depending on the impedance matching you might get noise.

[@shure]

Please read each of the tech bulletins listed at the link below - they contain valuable information about the causes and solutions to feedback in a sound system. www.shure.com/americas/support/find-an-answer/collection-of-feedback-troubleshooting-hints-and-links The most effective way to avoid feedback is to decrease the distance between the sound source (talker) and the microphone. Also, be very careful when using omnidirectional microphones, as they do not provide any rejection of unwanted sound sources. Other factors include the distance to the loudspeaker, room size, number of open mics, equalization, and how the mics are amplified (gain structure). All of these will influence the level at which feedback will occur.

[@charlesg5085]

Whenever I get feedback I grab a xm5800.

[@justindavidson6917]

Chris. Lyon looks like the voice actor who plays spongebob

[@gillihansmobilewelding]

Eventually, you'll have to stop blaming the mic and learn to mix Francis.

[@illteteka]

alright cool propaganda b ut this doesnt fix my problem

[@gillihansmobilewelding]

EQ